Why Does the Angle Mounting Bracket for Titan BrakeRite Systems # T4821800 Have Square Holes
Published 04/16/2015
Question:
Why this mounting plate has pre-drilled square holes? How can I attach it to trailer frame through square holes?
asked by: Tao L
0
Expert Reply:
Square mounting holes are usually associated with carriage bolts which have a square shoulder on them which prevents them from spinning while the nut is tightened.
On the Angle bracket # T4821800 that you referenced it looks like the round hole side of the bracket is used to attach to the actuator and the side with the square holes would attach to a portion of the trailer frame.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Angle Mounting Bracket for Dexter BrakeRite Systems
- Accessories and Parts
- Brake Actuator
- Disc Brakes
- Hydraulic Drum Brakes
- Mounting Hardware
- Brackets
- Dexter
more information >
Continue Researching
- Q&A: Replacement BrakeRite Actuator for Kit with Internal Board Issue
- Q&A: Dimensions Of Titan Angle Mounting Bracket for Titan BrakeRite Systems
- Q&A: Is There a Replacement Circuit Board for the Dexter Electric Over Hydraulic Brake Actuators
- Q&A: Recommended Gooseneck Ball for the Ford Factory Puck and Gooseneck Systems
- Q&A: Troubleshooting Titan Brake-Rite That Pump Wont Pressurize
- Q&A: Adding DeeMaxx Hydraulic Brake To A 2024 Brinkley Z2900 5th Wheel
- Q&A: Length of Threaded Portion of etrailer Hitch Pin Lock # e99047