Can the Lens on Optronics MC68 Series Trailer Marker Lights be Removed
Updated 04/02/2015 | Published 04/01/2015
Question:
I just ordered several of these and I cant seem to get the lens off. How am I suppose to mount these?
asked by: Carter
0
Expert Reply:
The lenses on the Optronics marker lights # MC68AB snap onto the base. Getting the lens off can be a little tricky. You can try a very small flat head screwdriver to gently pry it up but be careful not to slip and scratch the lens.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Optronics Clearance or Side Marker Trailer Light - Incandescent - Oblong - Amber Lens
- Trailer Lights
- Clearance Lights
- Marker
- Oval
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 3-1/2L x 1-1/8W Inch
- Amber
- Optronics
more information >
Continue Researching
- Q&A: Replacement Red Oval Trailer Light Lens Marked SAE P2 86
- Q&A: LED Replacement Lights For Grote 9015 and Glo Brite 118A/117R Clearance/Marker Lights
- Q&A: Replacement Hub & Drum For UFP HD-1377-10 & Hydraulic Brakes For Boat Trailer
- Q&A: Solution for Needing Replacement Bulb for Optronics Light MC68RB
- Q&A: Is the Optronics Clearance or Side Marker Trailer Light LED or Incandescent
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Compartment Door Thumb Latch for 1/2" Diameter Hole
- Article: Trailer Wiring Diagrams
- Q&A: Are Dexter Hubs 8-24 and 8-249 the Same
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Trailer Lighting Requirements
- Article: How (and Where) to Connect an RV Propane Grill
- Article: How to Winterize & De-Winterize Your RV (Simple Guide)