Hitch Recommendation for a Pop Up Camper
Published 03/26/2015 >
Question:
can i use any of your products to tow a small boat behind a fleetwood williamsburg pop-up trailer? the bumper is 2inch by 4inch by 2inch not completly enclosed and it appears to be pretty flimsy in construction. however, there is a circular knock -out plug that allows for access to a more sturdy metal box....
asked by: Jon R
Expert Reply:
To install a hitch on your trailer you will need to use a frame mounted hitch. Before you do that you will need to determine if pop-up can tow a small trailer behind it. Contacting the manufacturer with your model info will allow you to determine this.
If your pop-up can have a hitch installed on it you would want to use a frame mounted multi-fit hitch like the # 13703 that is designed to fit frames rails that are between 22 and 72 inches apart.
You will want to check your local DOT to determine if a trailer towing a trailer is legal.
I attached an install video for you to check out as well.
Product Page this Question was Asked From
Adjustable Width Trailer Hitch Receiver for RVs, 22" to 72" Wide
- RV and Camper Hitch
- Frame Mount Hitch
- 350 lbs TW
- 3500 lbs GTW
- 22 - 72 Inch Wide Frames
- Towing and Cargo
- Bolt-On
- Weld-On
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Wiring
- Shop: Roadmaster Reflex Steering Stabilizer with Mounting Brackets for Class A Motor Homes
- Q&A: Duty Cycle for Air Lift QuickShot kit part # AL25690
- Q&A: Can the SportRack Ridge Bike Rack SR2415 Swing Towards the Driver's Side?
- Q&A: Availability of Replacement Rear Bumper for 2013 Chevy Silverado 2500
- Q&A: Replacement Bolt Kit for Curt Front Hitch 31650 On a 2008 Ford Escape
- Q&A: Trimming/Removing Bumper Cover to Install Curt Class I Receiver Part # C11068 on 2009 Infiniti G37
- Q&A: Curt Front Hitch Receiver for a 2015 Ford Explorer XLT 4x4
- Q&A: Re-Securing Sensor On Factory Hitch for 2017 Mazda CX-9 with Curt Class III


