Where to Weld the etrailer Jack # TJD-5000 on a Trailer
Updated 03/16/2015 | Published 03/13/2015 >
Question:
Where can you weld the jack on so it is not distorted and will not work.
asked by: Charles H
0
Expert Reply:
Any where on the outside of the outer tube of the etrailer Jack part # TJD-5000 would work for welding the jack to your trailer. As long as you use a qualified welder there wouldn't be any problems with the jack warping.
I attached a picture that a customer sent us that shows a similar jack welded to a trailer.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Square Direct Weld Trailer Jack w/ Footplate - Drop Leg - Topwind - 15-1/2" Lift - 3,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Side-Mount Jacks
- Topwind Jack
- 2001 - 3000 lbs
- Manual Jack
- 29 Inch Lift
- Weld-On
- With Rectangle Foot
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Brake Controller Install on 1997 Chevrolet Pickup
- Q&A: Comparing TruRyde 10-36 Grease and Dexter 10-63 Oil Seal
- Q&A: Compatibility of # LHCS102-SI60C Center Cap and # AM20906 Valve Stem with Dexstar Mini Mod Wheel
- Q&A: What Makes 5200lb and 6000lb Dexter Axles Different Capacity?
- Q&A: Stability of Bulldog Square A-Frame Jack # BD195318 When Faced with Shaking Horizontal Load
- Q&A: What Is the Difference Between a BTR and BT8 Spindle
- Q&A: Replacement for a Triple Vision Backup Camera and Monitor
- Article: Trailer Tire Sizing
- Article: Trailer Lighting Requirements



