Installing a Front Mount Hitch on a 2008 Toyota Tacoma
Updated 04/07/2010 | Published 04/06/2010
Question:
Hello, Does the front factory tow hook have to removed to install the front hitch? Also, does any of the plastic have to be removed? Any help would be appreciated. Thanks,
asked by: Steve
0
Expert Reply:
I read through the instructions for this front mount, linked below, and you do not have to remove the OEM tow hooks. Provided the bumper cover and trim is the factory or OEM body, you will not have to cut, trim or remove any of the fascia.
expert reply by:
Patrick B
0
Product Page this Question was Asked From
Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Visible Cross Tube
- 350 lbs Vert Load
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Will The Curt Front Hitch 31313 Fit A 2007 Toyota Tacoma 4 Wheel Drive?
- Q&A: Removing Skid Shield to Install Front Mounted Receiver on 2014 Toyota Tacoma
- Q&A: Is Drilling Required for the Roadmaster MX Base Plate Kit on a 2007 Toyota Tacoma
- Q&A: Front Trailer Hitch Receiver That Will Allow For the Skid Plate To Mount On a 2008 Toyota Tacoma
- Q&A: Can a Front Mount Trailer Hitch be Used to Flat Tow a 1991 Jeep Cherokee
- Q&A: Will Gen-Y 5th Pin Boxes Void The Lippert Frame Warranty
- Article: Trailer Wiring Diagrams
- Q&A: Draw-Tite Front Mount Hitch on 2014 Toyota Tacoma
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Troubleshooting 4 and 5-Way Wiring Installations