How to Ground the Teardrop Clearance Lights CB-15AK
Updated 02/17/2015 | Published 02/16/2015
Question:
I just installed these running lights directly to fiberglass. But the lights do not illuminate? Do these lights have to be mounted directly to metal for proper grounding? Thanks
asked by: Ron C
0
Expert Reply:
The lights in the teardrop light kit # CB-15AK ground through the mounting hardware so you would need to either attach them to metal or have the mounting hardware go through a ring terminal on the end of a wire and attach the other end of the wire to a bare metal surface.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Clearance Light Kit - Teardrop Shape - Amber - Qty 5
- Vehicle Lights
- Marker Light
- Cab Light
- Multiple Lights
- Incandescent Light
- Light Assembly
- Teardrop
- Amber
- Optronics
more information >
Continue Researching
- Article: Can You Flat Tow a 2025 Chevy Silverado 1500?
- Q&A: Replacement LP Gas Detector for a CCI 7770.2 / Pre Tell 22 Detector
- Article: Trailer Lighting Requirements
- Q&A: Can a Single Attachment Point B&W Companion 5th Wheel Hitch be Used with a Sidewinder Pin Box
- Q&A: How to Use Lithium Batteries With a PD4060K Converter/Panel That Does Not Have the Li Switch
- Article: How to Replace an RV Roof Vent Cover
- Q&A: Best Replacement for Glo-Brite 9402-55-88 Stop Light
- Q&A: Does Demco CoachLink Monitor Work w/ Air Force One Braking System That Didn't Come With it
- Q&A: Replacement Air Conditioner for RV Duo Therm 57915.531
- Q&A: Replacement Jack Leg for HappiJac Truck Camper Jack System Model 4150
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: 4 Common Myths About RV Solar Power
- Article: Ram Trailer Tow Prep Package