What Size Hole Is Needed To Mount 1 Inch Mini Utility Led Light
Updated 01/14/2015 | Published 01/13/2015
Products Featured in This Question
Question:
What size hole to mount these please just ordered 4
asked by: Nick
0
Expert Reply:
The mounting hole needed for the Optronics Uni-Lite LED Mini Utility Light, part # UCL11CKB is 3/4 inches. I have attached a drawing of this light with the mounting hole dimension noted you can check out.
If you want to add a stainless steel trim ring to the lights you can order part # A11SSB.
expert reply by:
Jeffrey L
0
click to enlarge
Product Page this Question was Asked From
Uni-Lite LED Mini Trailer Utility Light w/ Grommet - Submersible - 2 Diodes - Round - Clear Lens
- Work Lights
- Utility Lights
- Exterior Lights
- Interior Lights
- Round
- Recessed Mount
- LED Light
- White
- Optronics
more information >
Continue Researching
- Q&A: Recommended 12,000 lbs Capacity Weld On Square Jack w/a 28-3/4" Lift
- Q&A: Trailer Brake Replacement For Hayes 6 Bolt 10k Axle
- Q&A: Current Version of Voyager Multi Camera Controller CSW3
- Q&A: Hub and Drum for 8,000 Pound Trailer Axle that Uses 5/8 Inch Studs
- Q&A: Do Mirrors Help to See Behind Towed Trailer?
- Q&A: Replacement for TDE LP85 Surge Brake Actuator
- Q&A: How Does The Optronics LED RV Exterior Scene Light Install
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: Trailer Lighting Requirements
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)