Brake Controller and Installation Port for a 2011 Ford E-450

Question

Question:

looking for the lug in for electric brake- where is it located on my 2011 e-450 super duty ford class c-

asked by: Dennis S

0

Expert Reply:

To see where the brake controller port is on your 2011 Ford E-450 motorhome check out the picture I attached. The plug will be behind the door that is pointed out using the screwdriver in the picture.

The # 3034-P harness you referenced is the correct harness to use.

For a brake controller I would recommend the Prodigy P2 Brake Controller part # 90885. This is our best selling brake controller because of how well it works and how easy it is to setup.

expert reply by: Jameson C

0

click to enlarge

Answer 1

Yes, we do have baby moon hubcaps that will fit the Dexstar Steel Mini Mod Trailer Wheel - 15" x 6" Rim - 5 on 4-1/2 item #AM20545. They are the Americana Baby Moon Trailer Wheel Center Cap - Chrome-Plated Steel - Qty 1 item #AM90086.

view full answer...

Answer 2

Your 2011 Winnebago Vista P26 was built on the Ford F-53 chassis. This is good because there is a brake controller wiring harness for this chassis. It is #3035-P. The connector on the vehicle this harness plugs into is located up under the dash…

view full answer...

Answer 3

If your vehicle has a factory brake controller plug, you can simply use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers – Ford, Item #3034-P, which will connect to the vehicle plug and the brake controller. On the new E-450…

view full answer...

Answer 4

On the new 2019 Ram 1500 the factory brake controller port is located under and behind the heater controls on the dash. I have attached an image that points to this location. You should be able to access the plug by simply reaching behind and…

view full answer...

Answer 5

We have a few idler hub options that use bearings with similar inner diameters to your current setup but you'll need to first verify the axle's capacity and the wheel bolt pattern to determine the best replacement. 5,200lb Axles with a 6 on…

view full answer...

Answer 6

Actually, the P3 now has the upgraded axis accelerometer like the P2. The Tekonsha P3 Trailer Brake Controller #90195, will work with both electric over hydraulic brakes on the trailer as well as electric brakes. It has a menu option on the display…

view full answer...

Answer 7

To verify if your 2021 Ford E-450 cutaway chassis for your Class C motorhome is pre-wired for a brake controller you will need to remove the storage slot in the top of your dash. I have included a install video below that shows how to remove the…

view full answer...

Answer 8

Hey Troy! It can seem a bit confusing at first, but basically all aftermarket brake controllers wire up the same way under the dash (might have to remove kick panel as they call it) -Blue wire runs to the back for the 7 way brake circuit -Red wire…

view full answer...

Answer 9

Hello Glen, I am glad that you wrote in. Since you have a 18,000 pound rig on a 2014 F-53 Chassis, you will want the Safe-T-Plus Steering Stabilizer with Mounting Hardware Kit - Custom Fit #ST88MR. The red ones are designed for a smaller camper than…

view full answer...

Answer 10

It sounds like you are on the right track for tracking down where the issue is. That said, the integrated brake controllers they were putting in trucks around 2008 weren't as reliable as the ones they've been installing since then. Especially…

view full answer...

Answer 11

Good question, Rick. The #ST28MR blue and #ST88MR white steering stabilizer are tuned for different F-53 weight ranges. The blue version is for 24,000 lb + GVWR, while the white one fits 16,000–22,000 lb chassis. What’s your coach’s GVWR or model…

view full answer...

Answer 12

I just checked with Tekonsha and they confirmed that the Tekonsha Plug-In Wiring Adapter #3034-P that you referenced will work on your E-450 motorhome. If you are also looking for a brake controller check out our Tekonsha P2 Brake Controller #90885.…

view full answer...

Brake Controller and Installation Port for a 2011 Ford E-450

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching