Can Bow Rollers Installed on Ranger Trail Boat Trailer Handle Weight or Only Guide Boat Loading
Updated 01/05/2015 | Published 01/04/2015 >
Question:
I have a 395vs ranger just bought the rollers on the front are they just for guides or can you put a little weight on them? Thanks.
asked by: Justin
Helpful Expert Reply:
Thank you for providing the photo of your boat and trailer and the bow guide rollers you have just installed. Without knowing the particular item you purchased or its rated capacity I cannot give you any 100-percent assurances.
I can advise that typically the rollers found at the bow end of a trailer are there for guiding the craft to its correct position on the trailer and not for bearing much of its weight. Typical power boats will have a much lighter bow than stern (due to the engine's weight being concentrated in the rear) and this means that most of the boat's weight load will be on the rear of the trailer and its roller or carpeted bunks.
Product Page this Question was Asked From
Universal Roller Brackets for Boat Trailers
- Boat Trailer Parts
- Rollers
- Roller Bracket
- Zinc-Plated Steel
- Redline
more information >
Continue Researching
- Video: Complete Breakdown of the Adjustable Lunette Ring with Channel
- Shop: Buyers Products 3-Position Adjustable Lunette Ring with 3" Heavy-Duty Channel - 10 Ton
- Shop: Buyers Products 5-Position Adjustable Lunette Ring with 3" Heavy-Duty Channel - 10 Ton
- Shop: Curt Lunette Ring with 3-Position Adjustable Channel - 3" Diameter - 12,000 lbs
- Shop: Adjustable Lunette Ring with Channel - 3" Diameter - 24,000 lbs
- Video: Buyers Products Lunette Ring - Coupler with Bracket - 337B20143 Review
- Shop: Ark Ezi-Guides Self-Aligning Boat Trailer Loading System - 20' to 28' Long Power Boat
- Shop: 1-1/2" Square Trailer U-Bolts (Qty 2)
- Shop: Replacement U-Bolt for 1-1/2" Wide, Square Trailer Axles - 1/2" Diameter - Raw Finish
- Video: All You Need to Know About the Universal Roller Brackets for Boat Trailers
- Search Results: wobble rollers
- Video: Breaking Down the Yates Ribbed Wobble Roller
- Video: All You Need to Know About the Yates Ribbed Wobble Roller
- Article: Trailer Lighting Requirements
- Video: Replacement U-Bolt for 1-1/2" Wide, Square Trailer Axles Review
- Video: Comprehensive Review: 1-1/2" Square Trailer U-Bolts (Qty 2)
- Search Results: receiver tube
- Q&A: Wiring for HydraStar Electric-Hydraulic Actuator for Disc Brakes # HBA16
- Q&A: What Causes Grease Leaking Out of Bearing Buddy Bearing Protectors
- Article: The Basics of Boat Trailer Bunks: Bunks or Rollers?
- Q&A: Can Dutton-Lainson Deluxe Roller Bunk # DL21741 Be Installed Directly On Current Wooden Bunk
- Q&A: How To Install Dutton-Lainson Boat Trailer Roller Bunks On Trailer Without Center Supports
- Q&A: Does Dutton-Lainson Boat Trailer Roller Bunk Come In Galvanized Version
- Q&A: Replacement Actuator for a TDE Model LP7000
- Q&A: Recommended Hub For Reliable BT150A Axle
- Article: Trailer Tire Sizing
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams


