Dimensions of the Bulldog Jack Support Plate # BDSPBQ50
Published 12/16/2014
Products Featured in This Question
Question:
I NEED TO KNOW THE SIZE OF THIS PLATE OUTSIDE LENGTH AND WIDTH. ALSO, I WOULD LIKE DIMENSIONS ON THE OTHER JACK PLATE THAT YOU SELL-ITS A HEAVIER ONE. THANKS
asked by: Gary
0
Expert Reply:
I attached a picture that has the dimension of the # BDSPBQ50 that you referenced.
I wasn't sure what other plate you were referring to so I grabbed dimensions for the # BD003135 and the # DL22763.
expert reply by:
Jameson C
0
click to enlarge
click to enlarge
Continue Researching
- Search Results: pintle hitch
- Search Results: hydraulic jack trailer jack
- Search Results: hydraulic jack
- Search Results: combination led trailer tail light ~ submersible ~ 6 function ~ 11 dio
- Search Results: hydraulic trailer jack
- Search Results: dot reflective tape
- Search Results: electric jack trailer jack
- Shop: Optronics LED Trailer License Plate Light w/ Bracket - 5 Diodes - Clear Lens
- Shop: Bottom Support Plate for A-Frame Trailer Jacks by Dutton-Lainson
- Shop: Atlas IV Vaquero Self-Contained Hydraulic Tandem Trailer Jacks - Complete Set - 20K
- Shop: Atlas IV Vaquero Self-Contained Hydraulic Trailer Jack - Bolt On - 10K
- Shop: Optronics License Plate Light w/ Mounting Bracket - Incandescent - Gray Housing - Clear Lens
- Shop: Combination LED Trailer Tail Light - Submersible - 6 Function - 11 Diodes - Passenger Side
- Shop: Combination LED Trailer Tail Light - Submersible - 7 Function - 14 Diodes - Driver Side
- Shop: Lift Assist
- Video: All About the Demco 50-Degree A-Frame Coupler without Jack Hole
- Video: Review of the Submersible, Under 80" Trailer Light Kit with 25' Wiring Harness
- Video: Redline Tie Down Anchors TFX225ACQ Review
- Q&A: Lock N Roll 50-Degree A-Frame Coupler Measurements
- Q&A: How To Mount 4-Way Connector To 2020 Mazda CX-5 With Trailer Hitch Receiver
- Q&A: What are the Dimensions of Trailer Jack Support Plate # BD003135
- Q&A: Is There a Reason Demco 50-Degree A-Frame Coupler # DM15349-52 is Silver
- Q&A: Can a Jack Hole be Added to an A Frame Coupler
- Q&A: How to Measure the Angle of Trailer A Frame To Determine if a 50 Degree A Frame Coupler will Fit
- Q&A: Can DM15349-52 Demco Coupler Mount Be Welded in Place
- Video: Comprehensive Review: Bottom Support Plate for 2-1/4" OD A-Frame Jacks
- Video: Complete Breakdown of the A-Frame Trailer Coupler
- Video: Hands-On with the Demco 50-Degree A-Frame Trailer Coupler w/ Jack Hole
- Shop: Trailer Hitch
- Video: Review of Air Lift Vehicle Suspension - F-250 or F-350 Rear Air Helper Springs - AL29DQ