The Curt Trailer Hitch Receiver #C11527 comes with all of the hardware in the attached installation video on a 2018 Buick Encore including the spacers and bevel (or conical) washers. I have attached a picture of the included hardware so that you can…
Curt Class II ball mount #C45510 will actually be a little better with ground clearance compared to Euro drawbar #C45591 because it doesn't stick out as far and does not have as much of the steel shank below the ball.
The etrailer.com Trailer Hitch Receiver part #E98841 when we installed it on a 2013 Hyundai Santa Fe was 13" from the ground to the top inside edge of the receiver tube. I called U-Haul and they said that the coupler height of the 4x8 cargo…
Tongue weight represents the maximum amount of downward force that can be safely suspended from the hitch, whether it be tongue load applied from a trailer coupler, or a hitch mounted accessory like a bike rack or a cargo carrying tray like the…
Ideally you want bunk boards that are at least 50% of the length of your boat, and want the to run from the stern and as far forward as you like. Since your boat is 16' Long you will want at least 8' of bunk boards, but I recommend going with…
The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
The only trailer component that determines the speed rating of the trailer is the tires. All you have to do is simply replace your current tires with one that is rated for highway use, like the Kenda Loadstar #AM3S120 that you referenced, and you are…
We can definitely get you the correct vehicle wiring harness. The Curt T-Connector #C43FR you have is for the LT and Premier Models of the Chevrolet Trax. The Tekonsha T-One #118751 you were looking at is for an LT or Premier Model as well. Since…
