Custom Fit 2012 Jeep Wrangler Unlimited Accessories

Great question! The Brake Buddy Classic 3 #HM39494 is a more basic system than the Brake Buddy Select 3 #HM39524 as the Classic just uses preset braking (which applies the brakes at a preset intensity when the inertia sensor detects deceleration)…

We don't offer a 235/75-15 tire pre-mounted on a wheel with the bolt pattern you're looking for, but we do offer an off-road radial part #WST54FR that could be purchased separately from any of the 15x6 aluminum trailer wheels we offer with a…

The Lock N Roll Articulating Coupler #336TS502 will come with two 5/8" grade 5 coarse thread mounting bolts and lock nuts. These bolts have a recommended torque spec of 112 lb-ft.

We have a second vehicle kit for the Demco Air Force One with the part #SM99209 which comes with just the components you'd need to install on the new 2021 Jeep Wrangler you have to use with the rest of the Air Force One #SM99243. I also attached…

If that aftermarket bumper is a Warn Rock Crawler number 74255 then yes, there are some base plates that will fit! Or if it is a Warn/Mopar bumper, part numbers 82211715, 82211715AB or 82209740AD & skid plate part numbers 82210401 or 82210401AB…

I wish it was that easy! But no you can use the tow loops in place of a base plate kit like the Blue Ox part #BX1133.

Sure thing, I'd love to get you all set up and in your way! For your 2015 Jeep Wrangler Unlimited with a stock bumper, you're going to need to grab a set of wiring #RM-154, tow bars #RM-676, a braking system #HM39524, and a base plate kit…

I spoke to my contact at Roadmaster and we came up with a solution for you. It will require a little bit of fabrication but it should work. What you will need first is the Roadmaster MS Base Plate Bracket part #1437-3. You will need to remove the…

Blue Ox is very thorough with their testing so if they told you that one of their tow bars like the #BX7420 would attach directly to the lugs of your AEV Premium Bumper it would be true this is possible and would work great.

We do have the correct fit for your 2010 Jeep Wrangler JK with the factory bumper, but the part you mentioned is not a fit for the stock bumper. I verified directly with Roadmaster that the correct base plate for your Jeep is the following: -…

Looking at the installation instructions for base plates #RM-521448-5 you will need to remove the air damn, trim it according to the instructions, and then reinstall it. Trimming is needed for proper installation of the base plates.

A vehicle end wiring harness using a 4-Way Flat connector should have 3 female plugs and 1 male pin. A matching 4-Way Flat trailer connector would have 3 male pins and 1 female plug like on the Mighty Cord Adapter 4-Way Flat to 6-Way Round, part…