New Arrivals

Stay connected on every trip. This adapter delivers Tow Assist odometer readings and fault codes to the app, giving you live updates while you drive and the reassurance your trailers ABS is helping you stay safe.

• Accessories and Parts
• Trailer Brakes
• ABS System Wheel Sensor Parts
• Electric Drum Brakes
• Bluetooth Adapter
• Dexter

This replacement inner member slide easily fits into the existing housing of your Dexter A-84 Series or Legacy UFP surge brake actuator. For use with single or double-axle trailers with hydraulic disc brakes.

• Accessories and Parts
• Brake Actuator
• Disc Brakes
• Inner Member
• Dexter

Replace the worn or damaged latch on your Dexter A-84 or A-160 actuator with this direct replacement kit. Includes latch assembly and hardware to restore secure and reliable trailer hookup.

• Accessories and Parts
• Brake Actuator
• Trailer Brakes
• Hydraulic Drum Brakes
• Disc Brakes
• Latch
• Dexter

Replacement Trailer Grease Cap Plugs for E-Z Lube Grease Caps

• Accessories and Parts
• Trailer Bearings Races Seals Caps
• Plugs
• Dexter

Upgrade your boat trailer's braking power with this rust-resistant GalvX disc brake. Kit includes 1 pre-greased hub, inner (L68149) and outer (L44649) bearings, rotor, caliper, mounting brackets, and lug nuts.

• Accessories and Parts
• Trailer Brakes
• Disc Brakes
• RH
• LH
• 3500 lbs
• Brake Assembly
• Hub and Rotor Assembly
• Dexter

Even one worn brake can make towing feel sketchy. Replacing a single ABS brake assembly brings back balanced braking and steadier control, so your trailer handles the way it should when traffic gets tight or the road gets steep.

• Accessories and Parts
• Trailer Brakes
• Electric Drum Brakes
• LH
• 3500 lbs
• Brake Assembly
• 10 x 2-1/4 Inch Drum
• Dexter

Replaces the shoe and roller for your passenger's-side Dexter 15,000-lb 12-1/4" x 5" air brake.

• Accessories and Parts
• Trailer Brakes
• Brake Shoes
• Dexter

Even one worn brake can make towing feel sketchy. Replacing a single ABS brake assembly brings back balanced braking and steadier control, so your trailer handles the way it should when traffic gets tight or the road gets steep.

• Accessories and Parts
• Trailer Brakes
• Electric Drum Brakes
• LH
• 7500 lbs
• Brake Assembly
• 12-1/4 x 2-1/2 Inch Drum
• Dexter

Your Fortress bolt-on cap has been holding it together - now it's time to return the favor. This service kit gives your Fortress cap fresh gaskets, oil fill plugs, and hardware it needs to stay leak-free and pressure tight.

• Accessories and Parts
• Trailer Bearings Races Seals Caps
• Service Kit
• Dexter

This replacement inner member slide fits into the existing outer member housing of your Dexter or Tie Down surge brake actuator. Fits actuator models LP80, LP85, and LP8500.

• Accessories and Parts
• Brake Actuator
• Disc Brakes
• Hydraulic Drum Brakes
• Inner Member
• Dexter

Replace worn or leaking copper washers on your Dexter disc brake caliper. These 7/16" crush washers provide a tight, reliable seal between the banjo fittings and calipers to help prevent brake fluid leaks in your hydraulic braking system.

• Accessories and Parts
• Trailer Brakes
• Disc Brakes
• Caliper Parts
• Hardware
• Washers
• Dexter

Weight distribution hitches are heavy, awkward, and usually a little greasy. Instead of cramming yours into a storage bay or losing it in the garage, this removable bracket mounts to a trailer's A-frame to keep your gear secure between trips.

• Accessories and Parts
• Weight Distribution Hitch
• Covers and Storage
• Brackets
• MORryde

Get some added traction with these slip-resistant and marine-grade step treads. These step treads are designed specifically for the MORryde Gen II StepAbove 3-step with 19-1/2" treads. Applies quickly and easily with adhesive backing.

• Accessories and Parts
• RV Steps
• Grip Tape
• MORryde

Replaces the mounting hinge pin for your MORryde Step Above RV Entry 2 steps (STP-202-MH-226-09). Pairs with hinge plates (MR66RV - sold separately) to install your steps in the doorway of your RV.

• Accessories and Parts
• RV Steps
• Hardware
• Pins
• MORryde

Turn your Mad-Ramps pivoting system into a set of standard loading ramps so you can get your equipment up and into your truck bed. Just snap these onto the tops of your ramps to keep them from pivoting while you load.

• Accessories and Parts
• Truck Ramps
• ATV Ramps
• Pivot Stops
• Mad-Ramps

Easily and efficiently store your Mad-Ramps system (MR2000) with this solution that keeps your equipment up off your garage floor. Just bolt the Mad-Mount to the wall of your shop or garage, and get simple storage for each piece of your system.

• Accessories and Parts
• ATV Ramps
• Truck Ramps
• Storage
• Mad-Ramps

Get some added traction with these slip-resistant and marine-grade step treads. These step treads are designed specifically for the MORryde Gen II StepAbove 4-step with 19-1/2" treads. Applies quickly and easily with adhesive backing.

• Accessories and Parts
• RV Steps
• Grip Tape
• MORryde

Pop these durable polycarbonate spacers onto the pivot bar of your Mad-Ramps setup (MR93ZV) to keep the ramps from shifting side to side.

• Accessories and Parts
• ATV Ramps
• Truck Ramps
• Spacers
• Mad-Ramps

Get some added traction with these slip-resistant and marine-grade step treads. These step treads are designed specifically for the MORryde Gen II StepAbove 3-step with 23-1/2" treads. Applies quickly and easily with adhesive backing.

• Accessories and Parts
• RV Steps
• Grip Tape
• MORryde

Replaces the tread cover for the standard, lower-step on your Gen 2 StepAbove RV steps with 19-1/2" wide treads.

• Accessories and Parts
• RV Steps
• Grip Tape
• MORryde

Camping's already an adventure - don't add scratched paint to the mix. These strap protectors for your Napier truck bed tent have your back - and your truck's! Just slide them over the tent straps to stop scratches before they happen.

• Accessories and Parts
• Tents
• Truck Bed Tents
• Straps
• Napier

Love your Napier Sportz SUV tent with the screen room, but wish the screened-in part was a little cleaner? This custom wall-to-wall floor helps prevent dirt and ground moisture from seeping in, so your gear stays clean and dry.

• Accessories and Parts
• Truck Bed Tents
• Tents
• Floor
• Napier

Got a Napier truck bed tent but need more space for your camping crew? This ground attachment is the upgrade you didn't know you needed. It turns your 2-person truck tent into a bi-level, 4-person camping mansion. Twice the space, twice the fun!

• Accessories and Parts
• Truck Bed Tents
• Tents
• Annex
• Blue
• Napier

Mount a 3/4" round trailer light with this flush bracket. Compatible with dozens of Optronics LED models. Black plastic housing resists corrosion. Surface mount design installs easily. Light and mounting hardware sold separately.

• Accessories and Parts
• Trailer Lights
• Mounting Hardware
• Grommet
• Diamond
• Optronics