Pop these durable polycarbonate spacers onto the pivot bar of your Mad-Ramps setup (MR93ZV) to keep the ramps from shifting side to side.
Features:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi, everybody, Andy here with etrailer.com. Let's take a real quick look at the stabilizing spacers for your Mad-Ramps pivoting ramp system. Now, when you pop these durable polycarbonate spacers onto the pivot bar of your Mad-Ramp Loading System for 2 1/2 inch trailer hitch receivers, identified by that model number that you see there on your screen, these are gonna keep the ramps from shifting side to side. So these are going to install on the two inch diameter pivot bar of your setup. They're made from durable polycarbonate, so they're gonna be very strong and durable for you. And hopefully, you can see, these are kinda hard to show, clear tubes over the camera here.
But you are gonna get these two long spacers and four short spacers. And let me go over some measurements with you. So on the long ones here, we're sitting right at 10 inches. And on these short ones here, looks like 2 1/2 inches. So two 10 inch long spacers and four 2 1/2 inch long spacers.
And again, these are gonna install on the two inch diameter pivot bar of your setup. Well, I think that's gonna wrap up our real quick look today. I do hope that it was helpful for you. Again, my name is Andy. Thank you for joining me.
.
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.