RV Slide Out Parts - Pollak

Hello Sandi, Thank you for sending over the pictures. They were very helpful in confirming the correct replacement. Based on the photos, the Lippert Replacement RV Slide-Out Venture Actuator with 18:1 Motor, 24" Long #LC119128 will work as a…

Hi Jimmy; is that 388807 or 368807? The 368807 motor was used in a lot of setups and can be replaced with the #LC368190. If the number is 388807 can you send me a picture? You can respond to the email with the link for this page and it will come…

Unfortunately, I cannot tell you what wiper seal you would need for your 2004 Keystone Outback. This is not something that is known just from the RV information. It depends on your particular slide-out. The best way to determine what wiper seal you…

The Replacement Standard Dual Rack Repair Kit for Lippert RV In-Wall Slide-Outs - Fixed Side, #LC84FR is the left side of the slide-out as looking at it, facing it, from the outside. The float side, #LC26VR, will of course be the right side as facing…

Hey Martin, The only difference I'm seeing between the Replacement Motor #TUS24FR and the Replacement Motor #LC125802 is that the TUS24FR has a 9000 RPM rating while the LC125802 has a 440 RPM rating while under load, which jumps up to 500 RPM…

Hey Jim. You can email whatever pictures you'd like me to look at directly to the email address you receive this response from. We do have a couple of wiper seals that are close to the measurements you have described. I've listed them below:…

Based on the picture you provided the Rubber Wiper Seal and Bulb for RV Slide Out #SR98FR is not the same design. It looks like you have a wiper seal in there and that the bulb seal is slid into a track or glued on either on or above the wiper seal.…

No, Richard it is not. The item #LC66FR is our part number for the Lippert RV Level-Hydraulic Pump Assembly 359167. That is not going to be the correct replacement for your hydraulic pump. Additionally, we do not have the one you need.

Hey Glen thanks for reaching out! I did some research and I wasn't able to find anything either, strangely enough. Did you happen to know who makes your slide out? For example, if you had a LCI electric through-frame slide out, and it measured…

Hey, Tim! I reached out to Lippert on this one to make sure we get you the right motor. The one you were looking at, motor part #LC368221 wouldn't be the correct fit for you. The one you will actually need to get is going to be motor part…

Hey Brett! The Curt TruTrack 2P Weight Distribution System #C69JR uses a ball with a 1-1/4" diameter shank. If you're planning to switch to a 2" ball you can use the #A-90. What kind of trailer are you towing?

Hey Eric, thanks for the information! Your older GE ARC13AACBL2 with 410a refrigerant is not going to be compatible with any AC components that came out this year. Everything has the new R32 refrigerant now so it's made all the 410a systems and…