Most Popular Clip-On Mirror for Audi Q5

They will not stay on the mirrors for a 2023 Grand Cherokee. After very careful installation they fell off because the shape of the mirror is rounded and you cannot get a good grip to hold the mirror on

The mirrors worked better than I expected and fit a Kia Sorento quite well. The design is pretty easy to mount and dismount once they're set up.Ive wind tested them to 72 mph when passing and they've held tight

After years of replacing mirrors from other sources I purchased a pair of these. There fantastic, plenty of adjustments. Got covid on vacation, really sick and did not properly install mirror. Not broken but scratched badly from asphalt at 55 mph. Purchased a replacement, scratched one is my spare.

Click to Enlarge

Easy to put on and adjust (2021 Toyota Tacoma). Can't beat the value for the price.

They were easy to install (once you figure out where the strap release button is located) and worked like a charm! I drive a 2017 Suburban and towed a Keystone Bullet (about 8 1/2’ wide and 30’ long) 160 miles today without any issues. The mirrors are not what I’d call pleasing to the eye, but they certainly provided an additional 18” of span, enabling me to look down the sides of the trailer and see cars behind me.

Click to Enlarge

Click to Enlarge

These are working out great! I'm now a wiz at putting them on too. They're great quality, sturdy and snug fitting. Very happy.

Click to Enlarge

Tried 2 other trailer mirrors and they did not fit our Jeep Grand Cherokee. These fit perfectly, as advertised, and go on very easily. Has made backing up the trailer so much less stressful. And great customer service to boot!!

I bought these mirrors to use on our 2021 Jeep Grand Cherokee. I used them just a couple of times and have decided to look for something else. Despite my best efforts and watching (and re-watching) the online video that shows them being mounted on my exact vehicle, I found that the soft pads that grip the back of the mirror could not keep the mirror in place for more than 30 minutes or so. It was warm (mid-80s) when I used the mirrors and the heat seemed to let the pads slip too much. I tried several different positions and adjusted the tension straps carefully, but no luck. They seem pretty well made and may well work well on other vehicles, but they just don't work with my Jeep GC.

Purchased a pair for our 2017 Jeep Grand Cherokee towing a nuCamp 400 from FL to AK and back. Three months and around 16k miles. Pros - other than an adjustment the second day, I never had to adjust the tension straps again. They were easy to mount and did not interfere with our mirrors folding inward. They weathered three months on the road without issue though I was beginning to worry about the straps becoming brittle. I noticed this once I removed them. Had I kept them, I would have used some silicon to rejuvenate the rubber. Cons - the only con is they shake. They shake to the point that sometimes I couldn't distinguish what exactly was behind me. I knew there was a vehicle, but the distortion from the vibration prohibited me from getting a clear view of exactly what was behind us. Impressions - they worked for our trip but I knew I would want something else for our next long trip, so we invested in a Furrion Reviewing Camera.

Click to Enlarge

Click to Enlarge

Click to Enlarge

My rating is less to do with the product and more with etrailer. I ordered an identical mirror (CIPA model 11950) on amazon for less than half the price, 1 day shipping, free delivery, and it did not fit my vehicle so I bought the one etrailer recommended for my vehicle. I thought it was CIPA model 7070 but that is just the etrailer model #. I got CIPA model 11950 which I already have. Now I need to return the ones to etrailer and I'm being charged $16 to do so. This could have been avoided if the CIPA model number was immediately visible in the description (it is there in small print at the bottom). Also, my vehicle's mirror (2018 explorer) is not the same as the 2018 explorer in the video and picture. So it's not accurate for etrailer to say it fits all 2018 Explorers.

So-so construction and design. With one modification they're more than acceptable. The arms and straps will slip and loosen if installed on triangular or tapered housings. Mirrors that have backs nearly parallel to the mirror face, and have upper and lower mirror edges that are nearly parallel are not affected. Adding a peel and stick plastic wall hanger to a tapered housing will stop the strap from slipping and loosening. The ball and socket mount is good and tight, but the stud on the ball is loose in the arm. I think most of the jitter and vibration others report is from this sloppy clearance that the stud screw can't tighten enough. I'll be addressing that as well. A nice option for those of us that a) don't tow a majority of the time and don't want full time extended mirrors, and/or b) tow with multiple vehicles and prefer to have adjustability to fit our 'fleet'.

Click to Enlarge

Click to Enlarge

Click to Enlarge

I ordered these for a 2023 Tundra after being advised to do so. The straps seem to be too short and to get them attached I'm really stretching then out and they're difficult to mount. I'm concerned they're going to pull off with so much tension and very little strap left threading through the tensioner.

Very good quality construction. Very good fit for a non-custom mount. Thick rubber straps are stretched over the car’s side mirror and hold the mirror well. My car is a 2017 Ford Expedition EL. Note: when you fold in the car mirror the towing mirror partially blocks the progress so that mirror stops early. It is still folded but not as completely as without the tow mirror. And yes, they are two identical mirrors so on one side the straps go up, on the other side they go down.

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

BUYER BEWARE!!!!!! I had great hopes for these mirrors. They look great. They appear to be very adjustable right out package. They fit on my Tacoma securely. They don't interfere with the function of the stock mirrors. Everything was moving along "swimmingly". Then I sit inside my truck to do the final adjustment (moving the actual mirror to get the correct setting and lock it into the "sweet spot"). The new Mirror is very stiff...doesn't want to move. Well, its new...so....Okay, I don't want to ruin anything...so.... No worries, I go get a phillips screwdriver to loosen the back screw a smidge so the friction adjustment can work . Come back start to back the screw out just a smidge...nope...still can't adjust the...wait...unscrew some more....that's not an adjustment screw at all. That just screws directly into the back of the mirror to hold it solidly in place. Worse yet, There is no friction mechanism on the back of the mirror at all. It is one solid piece of plastic. The molded plastic replicates the look as if it has the ability to move, but in reality....There is no way to do small mirror corrections once you have this thing installed. What the Actual people?????!!!!!!???? If you can't do minor adjustments to the mirror while you are in the vehicle, then the mirror is completely useless. I wouldn't recommend this product to my worst enemy. It's a piece of crap. DO NOT BUY!!!! A complete waste of time, money, and shipping costs. Now, I have to incur more shipping costs to send this POS back to etrailer. Hey, etrailer....Do Better next time!!!!

Click to Enlarge

Click to Enlarge

Click to Enlarge

These towing mirrors are good quality and easy to attach to the mirrors on my truck.

Finally, we got extended mirrors for our 2016 Sequoia. OEM mirrors are manageable but inefficient when backing up or switching lanes with a Travel Trailer. The only issue with the extended mirrors is that they vibrate to the extent you get hypnotized. They work best at slow speeds, backing in campgrounds or switching lanes at slow speeds. Sixty-five miles, forget it. Use your best judgment. If the mirrors are well molded into place, the vibration may be minimized. The team at etrailer, from start to finish, was fabulous. Thanks