# 1
Furrion Vision S Wireless RV Observation Camera System w/ Side Marker Light Cameras - 7" Screen
The rear camera works as one would expect. However, the monitor is not as clear as my old Voyager and the build is less then the Voyager. Once the monitor was mounted on the Ram mount I have on the RV dash the monitor started to make a rattle noise which is coming from inside the monitor. Currently doing the research for a better monitor.
Have not been out on the road yet but the install was easy even for a novice like me. My reflection 5th wheel was prewired so it was a plug and play for the rear camera. For the side cameras I used the two screws from the previous light. I put both screws in the top holes, (one behind the camera) as that seemed to secure it better then bothe screws not behind the camera. Instructions were a bit limited(or I didn't read them) on the side camera sync but I pressed enough buttons to figure it out. Picture looks great. Do watch for obstructions such as awning supports which will limit view. I also used silicone to keep the water out.
# 2
Furrion Vision S Wireless RV Backup Camera System w/ 3 LED Marker Light Cameras - 7" Screen
The rear camera works as one would expect. However, the monitor is not as clear as my old Voyager and the build is less then the Voyager. Once the monitor was mounted on the Ram mount I have on the RV dash the monitor started to make a rattle noise which is coming from inside the monitor. Currently doing the research for a better monitor.
Have not tested this on the road, so this covers installation. Instructions are clear and easy to follow, I was not clear about what to do with the trigger wire when you are retro fitting to an older RV, the FAQ on etrailer had the info, thanks for that. Installed this on a 2000 Lance camper sitting on a 1978 Ford F250 The side cameras were very easy to install, the backup camera required a little bit on modification to the camper. I did not like the monitor install options so did some simple modifications to the stand so I could use ram-mounts. Final setup is amazing
# 3
Rear View Safety Backup Camera System with Flush Mount Camera
Gives be great visibly on both sides and blind spots. Used the rear camera to watch my TOAD.
I bought a two camera setup, works great! One camera on the 5th wheel hitch, and one on the rear of the trailer. The camera on the trailer is setup to be on all the time I am driving. It really helps for backing up, but it is even better on the road. You can see cars coming up on the trailer and see if they are going to pass.
# 4
Buyers Products RV Backup Camera System w/ Night Vision - Rear Mount - 7" Screen
We purchased this camera to help get our rv in and out of a tight storage spot and to see behind the trailer while driving. The tow vehicle is much narrower than the trailer making it impossible to see behind the trailer even with extended side mirrors. This system allowed me to avoid cutting off any vehicles approaching from behind when changing lanes. The display was installed on top of the dash. The camera replaced the built in furion mount on the trailer. Due to short time, the cord was run externally. This kit is meant for a motorized rv, not a trailer. After opening the kit I realized I had to buy an extension cord to run from the display adapter cable to the rear of the tow vehicle. Then the cable could be disconnected at the trailer hitch. When using the system, the display is good, but very narrow field of view, vertically. So I can either see traffic or see the rear of the trailer for backing up. A second camera would seem to be the best solution but not my favorite one. The mic and audio did not work well. I could not hear my wife, but hilariously, I could hear cars at the rear. Might just be me ... I only ever used channel 2 which I thought was the only channel carrying audio. HINT: adjusting the volume was extremely painful until my wife figured out to adjust it on another unused channel. The brightness could not be adjusted making it bright at night. I aimed the display downwards to help. The instructions seem sufficient and are very brief. The system operates like a prototype rather than a finished model. But it does show the camera even with the display on the dash in the hot sun. We used it for the entire 3300 mile trip. It was on the entire time we were driving. I removed the display after returning home with my fingers, no tools. Overall, I am ok with the system. I still think it was the best purchase for me considering the cost of other systems and the wireless connection problems of other systems except perhaps for the most expensive. Note, I read someplace that some states may not allow a display to be on where the driver can see it while driving.
Ez to install—plug and play. Complete wired system—much more dependable than wireless and a lot less fussy to use. I cable tied the wires under a 37’ Class A. Plenty of wire. Used the old wire as fish tape. Old system was 17 years old. Compared to that, this one is high tech but reasonably priced. The flat screen is lightweight and it was EZ to cut the dash to fit. Very happy with this backup camera. Good clarity. In reverse, grid lines appear. It’s good. BTW The pics of the monitor on the box is the old monitor which is huge and heavy compared to this flat screen.
What our customers are saying:
"I received this order yesterday. Thanks for the outstanding service. I appreciate it! Thanks, Alex"