Most Popular Trailer End Connector for 2000 Ford Focus

Wiring worked perfect for my project. I replaced the wiring on my 14 foot utility trailer. If I was to do it again I would buy the next length up. I would have liked to have a little extra wiring if I was to ever need it.

Your sales staff is second to none. Keep up the good work. You shipped minutes after I placed my order! Very impressed! Marty

on time as stated

Replaced the wiring and lights on my 1992 boat trailer. I was able to get everything needed from etrailer. I think Optronics is of the highest quality and recommend both etrailer and Optronics product.

Routine trailer maintenance. Absolutely nothing worse than fighting trailer lighting or electric brake issues when traveling.

I installed this connector on my travel trailer. The original connector had become loose and would fall out if not retained by the tab on the bottom of the connector. After a year of usage The Pollack connector still snaps into place and fits tight. Good product.

Great product no issues at all. Product as described & fit properly.

Pretty straight forward. I used it to switch my European trailer's connection to be able to connect to my Wrangler's 4-pin trailer hookup. No issues. works great.

I've had this in use for over a year and they don't build them like they use to. I use this on a gooseneck trailer and the piece of plastic behind the spade connector for the clearance lights and brakes has melted, allowing the spade connector to lose contact with the plug on the pickup. So the lights would cut off in the middle of the night and would have to wiggle the connection till I could fix it. I have an older Hopkins plug and never had this problem. To fix the problem I ended up putting pieces of thin copper wire behind the spade and have done it twice since the plastic melted a 2nd time and once again the trailer clearance lights would quit working. Attached are before and after pictures.

Click to Enlarge

Click to Enlarge

After a year doing its job well.

I had to replace the old 7 wire cable because the male plug had been pulled off. I chose the WH54006-043 coiled cable. I used a 1/2 inch clamp to hold the cable up at the box and a Connect-to-Protect to hold up the male plug. The result Is clean and tidy. Thank you,

Click to Enlarge

Click to Enlarge

Click to Enlarge

This should work great, installation is still on my to do list.

Only gave 4 stars because it was a bit confusing. I have a lot of auto wiring experience; from car stereos,amplifiers and all manner of accessories. All of the info on etrailer indicated that the color coding didn't match up. So I went into it disregarding the standard color coding, when in fact it was just as it should be.

Good thick rubber and plug works perfectly.

The plug was missing the set screw and collar that compresses on the cable to prevent strain on the connectors when removing the plug. You can see the set screw clearly in the product picture.

I like this style of plug because it is molded and is important in keeping water out of the plug. It is conveint because it has the right colored wires. I have a water tight termination box with studs that it is wired into. Once I damaged the cable so I opened up the terminal box installed eyelet lugs on the spare pigtail, and installed it in a fiew minuets. I keep a spare on hand with lugs on it so if I have an accident I can quickly replace it. I also use these on some of my smaller tow behind equipment. that's why I like this size plug it isn't real bulky.

Easy to wire and very convenient indicator lights. Only thing to be aware of is the power light will stay lit if your trailer has a battery (e.g. a camper) and so it will put a small drain on it. Not really consequential if you're properly taking care of your battery anyway (disconnect or trickle charge when not in use).

Love how sturdy the product is, great quality!

very happy with product and service

What can you say about a 4 pin connector, It was what I needed and it was a good price.