Hey Bharat! The Curt 11180 was discontinued a few years ago. I'm sorry to say this isn't something we have in stock or that we can special order. It looks like some online retailers still have this in stock so I would run a general search for "Curt 11180" and see what you can find. The only other option is to have a custom hitch fabricated locally using the # E-9. view full answer...
Hello Ben. The Curt Powered Tail Light Converter # C59236 and the Tekonsha ZCI Harness # 119250KIT can both be used on your 2015 Audi A4 premium quattro s-line. The main difference is the Curt harness need to be hardwired, while the ZCI harness has clamps that go over the wires and does not require any cutting or splicing of the vehicles wiring harness. Generally, the ZCI harnesses are used on newer more high-end vehicles like your Audi since they are no-splice. view full answer...
Hey Ryan! As long as you clean the mounting points on your car before installation the # IN34XR won't scratch the paint. The coating and padding on the feet and clamps, along with the custom fit design, will prevent any scratches.
The square bars are the most cost effective but you might want to consider the # IN77PR with aero bars if you're going to use the roof rack a lot. The aero design goes a long way when it comes to keeping noise and drag down. The Benton ShellRaiser # B44FR is... view full answer...
The Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4" # C11448 and the Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4" # DT24950 are rated for the same capacities and attach in the same locations. I recommend the Draw-Tite above the Curt for this vehicle because the Curt class I hitches require a stabilization strap # 18050 for any bike carrier, cargo carrier, or other accessory under their warranty.
If you will be towing, I also recommend wiring... view full answer...
For your 2020 Grand Design Solitude 310GK that is pre-wired for a Furrion observation system we have the Vision S Wireless RV Observation Camera System w/ Side Marker Light Cameras # FCE48TASL-05 which would be all that you'd need. It comes with the rear and side cameras as well as a 5 inch display that allows you to easily view the cameras and select the different views as needed. view full answer...
Yes! If you have Yakima JetStream Crossbars installed on your 2002 Audi A4 Sedan with a bare roof, the Thule Pulse M # TH614 can clamp onto the crossbars with no problems. This is because the height and width of the JetStream crossbars are the exact same as the Thule WingBar Evo Crossbars.
If you need a complete roof rack, you need the following components:
- Yakima JetStream Crossbars - Black - 50" Long # Y00425
- BaseLine Towers for Yakima Crossbars - Naked Roofs # Y28TR
- 2 sets... view full answer...
Hey Agustin, the Thule Motion 3 Low Profile Rooftop Cargo Box # TH37PN is longer but it can be used with your 2015 Audi A4 Quattro. Do you have a roof rack already? view full answer...
To transport an 80 lbs bike with a 2011 Audi A4 you're going to need to install the Stealth Hitches Hidden Rack Receiver - Custom Fit item # 391AUDA4A5S509. There are no trunk mounted bike racks like the Thule Passage item # TH910XT, you were looking at that will handle anything near 80 lbs of bike. It's got a 35 lbs maximum weight capacity per bike btw.
The Stealth Hitches item # 391AUDA4A5S509 has been confirmed to fit the Allroad Quattro and Sedan models of the 2011 Audi A4. It is custom... view full answer...
Since I don't know the model year of your Audi A4 Avant Wagon I checked several years for trunk-mount bike rack fits. There are many Thule racks that will fit your A4 wagon if it is 2014, 2013 or 2012 and the link provided shows all rack fits that are common to these three model years. One cost-effective option is the Passage 2 Bike Carrier # TH910XT shown in the linked video.
If you have a different model year please advise and I can check again for you, or you can use the link to our... view full answer...
Both the Replacement Cam-Action Non-Locking Lever # TH23AD and the Replacement Cam-Action Lockable Lever # TH46FW work with the Thule ProRide XT Roof Bike Rack # TH598004. The difference is that one is lockable and one is not. The Replacement Axle Nut, 16 mm for Thule Bike Racks # 853-0446-01 would then be the correct barrel nut. view full answer...
The best 235/80-16 trailer tire we have for you is the Provider Radial Trailer Tire part # PRG80235. This tire has a 14 ply and load range G rating which is good for up to 4,080 lbs (per wheel). It has a maximum speed of 81 mph and comes with a two year warranty. The reason I recommend the Provider is because unlike most other trailer tire manufacturers, they bake test all of their tires which increases longevity.
I have attached a review video for you as well. view full answer...
We have confirmed with EcoHitch that the hitch part # 306-X7389 fits your 2011 Audi A4 Sedan. We had the chance to install the hitch on a similar A4 sedan and we found that it fit and worked well. Check out the install picture I attached. view full answer...
There is fascia trimming required to install the Curt trailer hitch part # C11448 that you referenced.
I attached a picture that shows where the trimming will be needed. view full answer...
The closest we come to the 2-1/2 inch center to center measurement of the mounting holes you have on your coupler and trailer are 2-1/4 inches, just as you said you have found.
The trailer coupler I recommend is part # CT-2002-Z. This is a 2,000-lb coupler that works with a 1-7/8 inch ball and the mounting holes are 2-1/4 inches apart. With the holes on your trailer tongue you would only be off by 1/8 inch on each. You could ream the holes a fraction and use this coupler.
You can have... view full answer...
First, for a trailer hitch, I recommend # DT24950 for your 2017 Audi A4. I recommend this one over Curt hitch # C11448 because the Curt hitch requires a stabilization strap, # 18050, when using the hitch with a bike rack and the Draw-Tite hitch does not.
I have included a picture showing where the fascia trimming is required to install the hitch. It is a small section underneath the vehicle that is not visible (unless you are under the vehicle).
This this or any Class I trailer hitch... view full answer...
Curt does have their hitch part # C11448 that is a fit for your 2023 Audi A4. If you install this according to the install instructions none of the sensors you mentioned would be affected. The bumper does not need to be removed which you can see in the attached install instructions. view full answer...
The Curt harness # C59236 you purchased is the correct one for the 2009 Audi A4 sedan and the odd behavior from the trailer lights, like the turn signals activating on the opposite side, is most often caused by an insufficient ground. This usually has a very simple fix.
Remove the ground wire ring terminal and apply sandpaper to that point to remove any paint, primer, undercoat (or rust) that could be blocking the clean ground connection. An application of dielectric grease like # 11755... view full answer...
In order to have a trailer hitch installed on your 2017 Audi A4, I recommend that you take your vehicle to a local RV dealer who has a service center as they would be the most experienced with this type of install. That said, we do not have any recommended facilities outside of our location in Missouri.
For a trailer hitch, I recommend the Curt Trailer Hitch Receiver part # C11448 because it requires the least amount of trimming. I have attached a photo for you of what it will look like... view full answer...
Go To Results