Bunk board not sitting flush against your hull? This EZ Loader bent plate bunk mounting bracket attaches bunks to upright brackets and allows proper angling for better hull contact. Sold as a single unit.
California residents: click here
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi, everyone. Steve here with etrailer. Let's take a look at our EZ Loader bunk mounting. It's a vent plate bracket in galvanized steel. So folks, again, this is a galvanized finish over the steel. It's a 3/16-inch-thick steel.
It's gonna be reliable for supporting the bunk mounting and also that zinc plate coating galvanized as well. It's gonna protect against rust in those wet marine environments. It's sold as a single unit, so quantity one, and it is a direct replacement part for the easy loader trailers. And again, this is gonna be what keeps, or attaches, rather, your bunk boards to the upright brackets on those compatible easy-load models. And it's gonna allow for proper bunk alignment.
So you just spin it to the angle you need it to before you tighten it up, and that's gonna give your boat's whole better, fuller contact. And that's gonna wrap up our quick look together, folks. I'm Steven. Thanks for watching.
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.