To see if this custom-fit item will work for you please tell us what vehicle you'll use it with.
Cracked your RV mirror but the rest is still good? This replacement glass is an easy fix without swapping the whole thing out. It drops right into place and gives you a clear view again so you can get back on the road without missing a beat.
When only the lower convex glass is cracked and your mirror head is still usable, replacing a full mirror assembly adds work and parts you are not trying to touch. This Burco Redi Cuts piece replaces just the side view mirror glass, restoring visibility without replacing the full OEM mirror assembly. You get the broken surface addressed directly, and your existing mirror body can keep doing its job on the road.
The lower mirror section matters when you need a wider look along the side of your RV or large vehicle. This replacement uses a lower convex surface, so the repair brings back the wide-angle view from that lower glass section. Once installed, you can use that lower mirror area again for checking nearby traffic, lane position, and close-side clearance.
Mirror glass repairs go sideways fast when the replacement is even slightly off, so the size needs to match before anything gets installed. This drop-fit glass is specified at 4-15/16" tall x 6-7/8" wide x 7-7/8" diagonal, with the longest diagonal measured from the inside upper corner to the outside lower corner. After confirming those measurements against your mirror glass, the replacement can fit into the correct lower mirror space and put that viewing surface back in use.
Replacing mirror glass often means working near old adhesive, cracked pieces, and tight mirror openings, so the edge finish matters during the repair. This replacement glass has smooth edges for safer handling while positioning the new piece. During installation, you can handle and place the glass with more control, then get back to using the mirror for a clear, reliable reflection.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi, everyone. Steve here with etrailer. Let's take a look together at our Burco Redi Cut RV Side Mirror Replacement Glass. Now folks, this is a custom fit application, so make sure you're double checking your measurements and the fit guide here at etrailer to be sure you're getting the right parts for the right RV the first time. Now, what I like about this is you're gonna save a lot of money by not having to buy that full OEM assembly. This has been compatibility design.
It is a non-heated OE mirror, so it's just the glass. There's no heater or anything. You have these six round discs and those have adhesive on the back as well as being padded, and that's gonna aid in the installation. So make sure you're double checking the install instructions that come with it. To measure, you wanna go height, so I got 4 and 15/16 tall.
The widest part was 6 and 7/8 inches wide. Keep in mind, this is curved, so make sure you're just being very close to those measurements. If you have like a seamstress, those, you know, kind of cloth rulers that roll up, that's probably gonna be the best thing to get around that curve and get a more accurate measurement. And then diagonally across, same thing, tip to tip, I got 7 and 7/8 inches. So again, folks, this is a DIY replacement.
It is an exact fit. It's gonna replace that factory mirror. It has nice smooth edges, and as you saw it gives you a nice clean and clear reflection. You can see the whole studio there. So this is the Burco Redi Cut RV Side Mirror Replacement Glass.
I'm Steven with etrailer. Thanks for watching.
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time.




Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.