Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Once you've found the perfect spot for your boondocking adventure, slide this tray out of your RV so you can easily grab your generator and set it up. You won't have to break your back trying to dig it out of a cluttered cargo compartment.
Features:
Specs:
Note: Do not run your generator while the tray is inside your cargo compartment.
Need a way to easily top off your generator with gas during your next off-the-grid camping trip? You can slide this tray out of your RV or camper so you can easily maintain your generator or grab it whenever you need to run it and power your appliances. You won't have to spend time digging it out of a cramped or cluttered storage compartment. This tray is also great for storing an ice chest, a Blackstone grill, a toolbox, and other camping essentials.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
What's up, everybody It's AJ with etrailer.com. Today, we're going to be checking out the MORryde sliding tray. Now you can use this on generators. We have it set up on batteries today, locks into place. You don't have to worry about going anywhere when you're going down the road just pulling the latch, slide it back out. It's gonna make it really easy for us to work or replace these batteries.
Now we don't have to climb into the compartment and hit our head on anything. Let's check it out. Now there's gonna be five different sizes of these sliding trays out there so make sure you measure the compartment. Think about what you're gonna put in it and where you want to put it to get the right one. We have these smaller versions today, the 15 by 16 and we're using two batteries in here.
Like I said, easier to access and pullout here and work on it than try and reach in there and mess with anything. So some of the other ones are gonna be different shapes so there's more square or rectangles. When you wanna do it with a generator you're gonna need more space to put that generator in place to do the same thing, slide it out and work on it easier out of the compartment than in. It's gonna be really easy to use and operate. You have the latch here.
You got the ball that you can hold onto to lift this up. This is gonna lift the striker outta the way. And then you have this handle on either side to grab and pull the tray out. Now it does fully extend a hundred percent. We're held back by wires on the batteries right now but that gets it out of the compartment quite a bit.
I'd like to point out the holes here and the tray. It comes with these straps as well. So you can also strap down whatever you're setting in the tray. Again, just another thing to keep the batteries in place so they won't be moving around while you're driving down the road. Depending on which tray you get the weight capacity's gonna be a little bit different. The biggest version is gonna be 25 by 26. That's gonna be rated for 300 pounds. Now all the other ones like the one we have here is rated for 250 pounds. So just keep that in mind with what you wanna load up on the tray. Now this one's already installed, but I wanted to go over the processes a little bit so you have an idea of what you're getting into. So it's all gonna come assembled so you don't have to worry about putting anything together. And what you're gonna do is attach this frame to the bars of where you want to put it. So there's gonna be pre-drilled holes in here. So when you set it up on the frame make sure it lines up where you want it and you have to get your hardware separately. It does not come with hardware but then you can run some bolts in to hold it in place. So you can see the bolts on the inside here of this lip. They also welded this one in place so it's really not going anywhere. Overall, I think it makes it way easier to either access the batteries or the generator you have in here plus servicing the generator with you're changing out the oil. You don't have to try and lift it up and out of the compartment, set it on the ground worry about it. You can just slide it out and start to work on it that way. It's heavy duty. It doesn't feel like it's gonna have any issues. I like how easy it's to slide in or out and that latch feels real good too. I don't have to worry about this starting to slide out or anything if I take a weird turn. Well, I think that about does it. Thanks for hanging out and hope this helped.
Customer Satisfaction Score:
95% were satisfied with this product
5% of customers were not satisfied
Ratings & Reviews
It’s well built and fit my application perfect.
I ordered the first sliding drawer that was the wrong size. The etrailer staff was helpful in seeing that I would be able to order the correct one properly. This tray allows me to pull out the generator without having to set it on the ground and reload it. On a 2012 work and play 18 ES.
Bought as a battery tray instead of using it for a small generator 4 6 volt golf cart batteries fit perfectly and rolls in and out effortlessly. Latch is very positive and keeps tray locked in.
Saw photos with the Honda 3000is generator. It actually sits on the edges or needs about a 1" shim under the feet. My generator is sitting a lot higher than I wanted.
One of the holes for the latch was misaligned. Customer service offered to replace it, but we agreed on a heavy discount. The slides work great, but I needed the latch to work. I am jury-rigging it so it will work for me.
So far, I’ve used this slide out for a 5000 W generator out of the back of my detailing van. The generator weighs 110lbs without fuel so it’s being used quite often with about 150 pounds total being slammed in and out of the van multiple times a day. It’s still as smooth as the day I bought it and installed it. I use harsh chemicals all the time and the finish is even holding up very well. I could not be more impressed and I would absolutely recommend this slide out for anyone that needs that absolute reliability every single time!
Awesome customer service and pull out Generator tray works great and is going to save my back this camping season.
We bought the slide out tray specifically for our generator, which is a predator 3500. It has worked to our expectations and highly recommend it.
I am using for a battery slide out as I recently switched to LiFePo batteries. This has worked great for this application as it is very robust, the dimensions were perfect and had excellent weight capacity.
Item is exactly as described. I installed this so I can service my 5th wheel batteries without having to lift them out of the RV. Previously I had to lift each battery out of a cramped compartment to check and service them. 6volt batteries are HEAVY! Now a quick slide out!
Seems solid and we will know as we use it.
The parts were sent on time and correct. Just missing one portion that was made correct. I would order again without any issue
fast shipping
Ordered two drawers: neither would not open to a full extension. Had to pound on them for a while. Eventually, got them to fully extend. May want to check the drawers for full extension prior to shipping. Otherwise the product works fine.
Sierra K.
12/21/2021
Some lubrication spray may be needed to maintain smooth extension.
I used this tray to replace the tray that my batteries were in. One thing you'll find is the batteries will rub on the pop rivets that attach the rollers to the tray, eventually wearing a hole in the battery. I inserted spacers to keep the batteries away from the rivets. The tray I removed had the rivets installed from the other side of the assembly.
We’re so pleased with how well this is made. We were replacing the original battery tray (Lippert) in our motorhome and were worried that ordering a different brand would be a problem. This tray is made of much thicker metal and is extremely well built. Not only was it less expensive than the other brand, the mounting holes matched exactly with the ones where the old tray was removed. Thank you for a great and affordable replacement.
My old battery tray was a rusted mess that required me to sit on my butt to push it in with my legs. This replacement is a dream! I was able to install it myself in a short amount of time. I've never installed anything like this, but it was easy. My old bolts were rusted (and some broke removing them) so I had to visit Lowes and get help picking out new hardware. That took longer than installing the drawer! I did make a little template out of a large paper bag so I'd know where I wanted the drawer and where to drill my holes--since my two hands weren't enough to hold it in place while pulling out the slide and also mark my spots. If you have someone to help with that part, use them. The drawer slides so smoothly, and it securely holds my batteries with the included straps. I did stuff a small piece of wood between the batteries and each side to ensure the rivets others mentioned don't pierce my batteries, but I'm not sure they would anyway. Just being extra cautious since I had the wiggle room. Highly recommend the product and etrailer. It's my third or fourth purchase from the company, and their customer service is consistently excellent, shipping is lightning fast. (For perspective, I'm a 40-year-old, female, first-time owner of a 21-year-old RV with some handy skills but far from a pro.)
I purchased this slide-out tray for a custom project in my Peterbilt 567, and I couldn’t be happier with it. The tray is extremely sturdy, smooth to operate, and built with outstanding quality. It feels heavy-duty and very well made, exactly what I was looking for. Installation was straightforward, and it works perfectly. I highly recommend it to anyone looking for a high-quality slide-out tray.
Do you have a question about this RV Cargo Slide?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Roy
4/24/2026
Still in Perfect working order, They are being used to acesss Gyro systems on two of the SpaceX recovery vessels. I did install a backup bracket to hold in place in case of very rough sea conditions but so far the Ball latching system has held up.