Ventline RV Vents and Fans
- V3094-603-00
- Vent
- Roof Vent
- 12V Fan
- Tinted
- Manual Lift
- Ventline
- Plastic
This roof vent has a single-speed fan that circulates air, and it opens quickly and easily with the spring-loaded handle. The handle locks the translucent, wedge-shaped dome into 10 different positions. Install kit and garnish sold separately.
Features:
- Roof vent has a fan that pushes stale air out of your RV, camper, or enclosed trailer
- Vent allows air to circulate while your RV remains locked and secure
- 12V DC, 8-blade, single-speed fan
- On/off switch is mounted to vent
- Fan rotates counterclockwise
- Easy-to-use handle lets you quickly open and close the vent from inside your RV
- Spring-loaded handle locks into 10 different positions
- No gears - opens vent faster than a standard crank handle or hand knob
- Ergonomic T-shape is easy to grip
- Aerodynamic, wedge-shaped dome (or lid) is made of durable smoke-colored polypropylene
- Translucent dome allows some light through
- Polar white screen snaps out for easy cleaning
- Vinyl weather seal helps keep water out when vent is closed
- Manual lift design
- White, 1/4" thick mounting flange is built in
- UV-resistant, long-lasting specialty polymer plastic construction
- Smooth edges won't cut you during installation
- Works well with all roofing materials
- 2-Wire design
- Black wire is power
- White wire is ground
- Interior trim piece (or garnish) and installation kit sold separately
- 4 Mounting points on flange allow for installation of a vent cover (sold separately)
- Made in the USA
Specs:
- Rough opening size: 14-1/4" wide x 14-1/4" long
- Overall dimensions (outside of flange to outside of flange): 16-1/2" wide x 16-1/2" long
- Vent extends above roof:
- 4" When closed
- 9-1/2" When fully open
- Overall fan diameter: 5"
- Fan shaft diameter: 0.091"
- Fan capacity: 100 CFM
- Power draw: 1.2 amps
- Limited 2-year warranty
Note: Not for use above tubs, showers, or range cooking surfaces.
Spring-Loaded Handle on Ventline E-Z Lift Ventadome
![E-Z Lift Ventadome Handle]()
The easy-to-use handle on the E-Z Lift Ventadome lets you quickly open and close the roof vent from inside your RV. Unlike a standard handle or knob that can take time to crank, the handle on this vent is spring loaded. Simply pull on the handle and move it into one of 10 positions to open the vent. Each position offers a different degree of opening, and the handle locks into place. Also, the handle's T-shape makes it easy to grip.
Integrated Mounting Points for Vent Cover
![Vent Cover Mounting Tabs]()
There are 4 mounting points built into the flange of this roof vent. These points allow you to install a vent cover (sold separately) over the roof vent.
Installation Instructions
Note: Interior trim piece (garnish) and installation kit with screws and sealant are sold separately.
- Mark desired location for vent. Be sure to choose a location between roof joists.
- Cut a 14-1/4" x 14-1/4" opening through roof and ceiling. (Or use existing opening if you're replacing a standard 14-1/4" x 14-1/4" vent.)
- Apply sealant to bottom of flange. Be sure to surround each screw hole.
- Insert vent through hole with screen frame extending through roof cavity and hinge of vent toward the front of the vehicle.
- Mount to roof with #8 screws.
- Remove screen frame to make electrical connections.
- Connect to 12-volt DC power source.
- Replace screen frame.
- Attach interior garnish piece with #8 screws.
V3094-603-00 Vent Line Easy Lift Ventadome RV Roof Vent w/ 12-Volt Fan - 14-1/4" x 14-1/4" - Smoke
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.