Replaces the pin for your Western, SnowEx, or Blizzard snow plow shoe assembly. Comparable to Western, SnowEx, or Blizzard part number 93010.
Features:
Specs:
California residents: click here
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today we're taking a quick look at the replacement Shoe Lynch Pin for Western Snow Plow shoe assembly. Now this little quick snap pin is going to get your shoe assembly in place. It has some pretty good tension on that ring to help keep it locked into place whenever you're using your shoe. It has that offset to apply tension there. So that ring will snap over and keep everything in place.The pin is about 1-3/4" long from that little lip there at the top to the bottom of the pin itself. Overall the total length of it, flip it around, is about 2-1/8".
Our ring diameter, outside edge to outside edge is about 1-7/8" in diameter.The pin has a flat spot on one side to line up with the hole that matches up with your shoe assembly. The width of the pin is about 3/8". This is going to replace the OEM number 93010.And that's going to do it for our look at the replacement Shoe Lynch Pin for Western Snow Plow shoe assembly.
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.