Most Popular Overhang for Toyota RAV4

Super easy to put on,perfect fit. Worked great with my 20 yr old yakima rocketbox! Thank you

Good looking Roof Rack, fairly easy to install but, I broke one of the end caps and missing an Inner Foot Pad.

Worked as designed. Some measurement needed to cut and install seal between attachment brackets, and little trial and error to center/balance the bar across both points (just as one would with a cargo box).

I've had these on my car for a year now. They are decent for the money and I think they look pretty good too. One very weak point is the plastic end caps. They snap on and are flimsy. I lost one in short order and broke another one sliding a sheet of plywood over it. It would not be hard for them to design a better cap that is fastened better to the rails. I 3D printed new ones that work great and installed with a screw.

The crossbars came together with all mounting hardware, platforms and legs. Evertyhing arrived together in short time and was raasonably easy to assemble. The quality is good and solid, and all at a good price. A year later, they still look great and perform well. I highly recommend purchasing from etrailer.

Purchase for a 2019 Jeep Grand Cherokee, black rails. Perfect fit.

I ordered the Yakima roof rack, with the Hullyrollers for the back crossbar and the Mako saddles for the front crossbar to use with my kayak. It arrived just like they told me and I put them on my car the eveningit arrived. Got to finlly use the roof rack on June 22 to go out kayaking and it worked great. Only thing is I did not know about the air reflector piece for the front crossbar. Now I will be ordering it to help with the wind noise.

Great rack, go on fast, easy to install and work well on my VW TDI wagon. Care has to be given and follow the instructions for the install to what type of rails you have. Works great carrying the VW luggage carrier and plan on using it to carry kayaks as well. Just have not decided what kayak rack type to get yet.

One bar slid out on our first road trip. The "grip" that it slides into can't be adjusted. I am in communication with Yakima about this as Etrailer said that's the route that I would need to go. Very frustrating.

From start to finish, the folks at etrailer -- and I spoke to several people there, so it was a consistent corporate vibe -- were fantastic to deal with. There were delays in getting my product that were on the supplier side and out of etrailer's control, yet etrailer folks kept me up to date and also worked on a customized solution. My goal was to be able to carry my surfboard on the roof of our 2019 Hyundai Santa Fe to the beach more than 3 hours away. But the particular model we had had no existing racks, no recessed areas, nothing to fix racks to. Not even the dealer had a solution. I was sh*t out of luck. But etrailer hooked me up. The racks did take me a while to put on, but most of that time was fine tuning to reduce “hum” while driving. I’m very happy with them. Thanks to etrailer, I have gone surfing and can go surfing whenever I'd like to.

The only problem I had, was when I watched the video showing how to install the rack, I did not realize that the actual installation process was a lot more complex. For example, the woman who was in the video only showed the installation one rack (I believe itg was the back rack and she gave the width measurement for that one. The front rack was already on the car and the woman neglected to say, "check your manual. The width of the front rack (may be) different than the back. She also did not explain carefully that there were three different screws that needed to be adjusted for a proper fit so the towers were properly adjusted for yoiur specific car. (My car is a 2018 Chevy Volt.) (I also bought Yakima kayak cradles from you guys, which were easy to install.) However, I blame myself for not reading the manual carefully, so when I installed the racks, they did not fit right and one of them actually fell off while I was driving. (Luckily there were kayaks on and no one was hurt. The two towers were damaged but luckily the rack and the kayak cradles were fine. I called etrailers and was told I had to contact Yakima, which I did. I explained to the Yakima customer service rep that I was at fault for trusting the video and not reading the manual carefully and after asking me to send him photos of the damaged towers he sent me two new towers for free, as well as another torque wrench, so I could work with a second person. This time I read the manual carefully and watched the Yakima video many times during the a week before I felt confident enough to try installing the racks again. This time they fit perfectly. I love both the rack and the kayak cradles. I use them to transport my two kayaks down to the Hudson River near my house and have also used them to carry the kayaks to a family camping site 50 miles away, confident they are safe and secure. But please, review the video you put out for the installation of the racks onto a 2017 Chevy Volt, and either correct the shortcomings by doing it over, with an explanation about the adjustment of the widths, and also reading the manual and finding the correct positions for the adjustment screws. (Or delete it and refer your customers to the Yakima installation video. Though it’s more generic than yours, at least the tell the customer to refer to the manual.

Super happy with my purchase from e trailers purchased yakima roof rack. Knowledgeable sales rep.Help me through the process on purchasing my roof rack Recommended to anyone quality parts

Two issue- 1) my old Hull-a-ports don't fit perfectly on them. Had to do a little jerry rigging. It works, no problems but it would have been nice to know. 2) without any attachment on these bars, at speeds >40 MPH (70 KPH) These things cause the most God awful scream that almost precludes opening the windows they are so loud.

Great looking product. Fits very well on the car and the bars are actually pretty quiet. It is somewhat a pain to mount and dismount so plan on 30-45 minutes at least. In my opinion, if you put them on leave them there for the season as it is not very friendly to mount or dismount.

The Rhino Rack HD crossbar kit for tracks fits my SyneticUSA Pro retractable cover perfectly. RR includes several track nuts of different sizes to match to your particular track. I love the quick detach capability of the towers and that they also lock for security. The HD bars are essentially the same dimension of 1 5/8" unistrut/superstrut so you can find all sorts of attachment hardware outside of what RR makes. This makes it easy to securely bolt your gear down to the cross bars and customize with easy to find hardware at your local home depot. The 65" HD bars are perfect for a mid size truck like my Tacoma.

The rack more than exceeded my expectations. It was easy to assemble and mount on the cap of my Tacoma truck. I was pleasantly surprised by the aerodynamics which virtually eliminate wind noise, even at highway speed. I pirchased the rack as a permanent mount for a 4rod flyrod holder which I use daily for fishing. The Rhino keeps everything “tight and right”. It has worked perfectly for nearly three hundred trips and over 15,000 miles this year.