Most Popular RAM for Keystone Passport Travel Trailer

My Jack arrived DOA. After installing it on my trailer, the Jack didn’t work. The manual crank handle came in handy because I didn’t have time to troubleshoot and repair it at the time. It was just a wire that was no longer connected to the switch but I have to tell you it was extremely disappointing to receive a brand new item that didn’t work. If it had worked out of the box, I’d give it a five star review. You should consider soldering and heat shrinking the wires to the switches or making the wires longer so they aren’t banjo string tight and putting the lug at a strange angle.

This particular jack fit my 2001 Horse trailer perfectly. I had it installed in about 2 hours due to clearances on this particular type of Tonge design. Otherwise with a couple box end wrenches and a hydraulic bottle jack this jack could be installed in 30 minutes. It appears to be a very good product for the money. Also, it has plenty of lift capacity. 8000 pounds which is perfect for my trailer.

Hello, Please see pics below of broken weld on jack. The jack was just installed and in use for about 7 days and noted the broken weld. Jack functions as described, however, we question the durability of the jack.

Definitely has the power I need however I can't open my tailgate when my camper is hooked up. 5 stars for power.

The cover over the light on the jack was not attached and there was a piece broken on the case. I thought of sending it back but decided quicker and easier to just repair it myself. See photo

After a year still works great……easy to install, and didn’t need the light because I had already installed a rear utility light to my truck to hook up trailers but for those who don’t have a back light it is much easier than a flashlight. Great product!

The Bulldog Jack has been great!

I have had problems with inadequate clearance between the lift gate of my Ford F150 and tongue jack motors on prior travel trailers. Some lifts allow the motor to be rotated sideways, but the bulky Lippert that came with my new Winnebago TT didn't. The Bulldog is made to be mounted either forward or sideways and has a particularly narrow body. Installation was a snap, and I drilled holes to rotate the bubble level to be aligned fore and aft. I opted not to use the clever Plunger Pin Kit which is mounted to be pulled from the side because when the unit is mounted sideways, the pin with its fairly stiff spring would have to be deployed and operated either fore or aft beneath the hitch or the tongue assembly. So I am using the original lynchpin assembly for the drop leg. Now I have plenty of clearance between the Bulldog lift, the F150 drop gate and the propane tanks and cover.