Most Popular Rectangle for Coachmen Freelander Motorhome

Quite easy to install and fit my Coachman Freelander perfectly. The prior ones were not sealed, filled with water, and blew the fuse fuse. Beware of the cheaper version on Amazon as they have the same poor seal problem as the original lights which died after <5 years.

Command Triple LED Tail Light Review They work great once they are installed. I have 2002 Gulf Stream Ultra on a Ford E450 Frame. The problem is the actual installation. Command does not include install instructions. What may needed if converting from incandescent bulb to a LED system is a 12 Volt 50 Watt 6 Ohm resistor. Installing a resistor parallel between the Brake/signal and Common wire will be necessary to overcome the hyper-flasher bulb out detection system. This high power resistor needs to be mounted on a metal surface to help disapate the heat created. In my case, I mounted the resistor to 3/4 metal pipe banding. The resistor was suspended so that is would have great air flow. Furthermore, size of the light should be slightly larger than 14 w x 6 7/8 . In my case the tail light was not big enough to cover the old light screw holes. I made this work by centering the light and using lap sealant as a finishing water proof bead. After a long road trip and many signal turns and brake presses the tail lights do look and work great.

It was an exact replacement and workded fine.

Thus far a good light, I am using it as a rear foglight on my truck. It's been surviving the Florida rains, time will tell how it holds up to the elements, I'll write a follow up during our foggy season here. It's a bright light, not too large. My use may be unorthodox, but in the couple of weeks since I installed it still tests good.

Always look forward to getting parts from etrailer. Shipping is decent and parts are as described.

My two year old yacht club trailer side marker lights had a mind of their own and would inadvertently decide to energize or not. The bulbs could not be replaced as these were a one piece unit.I ordered two LED marker lights from etrailer and after replacing the incandescent fixtures I haven't had an issue. I predict my rear lights being next.

These small amber marker lights fit my old existing incandescent light trailer mounting holes perfectly!

Before installing these marker lights on my boat trailer, I touched the power wire and ground wire to the terminals on my truck battery. This light is at least 2X brighter and more vivid than the older LED lights that I am replacing. The older lights had a very suspect push on connector that would rattle off from road vibration. These Optronics have a sealed, through the back, power and ground wire. Far better!

Replaced all the clearance/marker lights on my 2007 RV. Nice upgrade to the LED and very easy installation.

The clearance lights work perfectly. The sales lady went above and be beyond to make sure they were correct. She even went back in the data and found a previous order I made. Very professional!

I like that it has an Led light.

We bought these running lights to replace nonworking lights on our Keystone Cougar 5th wheel. They were a perfect fit.