Most Popular SuperSprings Intl for 2022 Honda Pilot

Easy install in 15 minutes. It did help with sag and I noticed an immediate difference on the positive side. I installed these on a Honda Pilot used for towing a small Teardrop trailer. I am using these in conjunction with Timbren bump stops and am pleased with the results. I was going to install airbags but did not want the hassle of checking air pressure and these being maintenance free was a good option.

I installed a set of 1125 Sumo Springs in the rear coils of my Toyota RAV4 Limited Hybrid AWD to increase the spring rate ahead of a cross-country road trip. My RAV4 really sags with a rearward rake when passengers + rear cargo are loaded in the vehicle. This impacts the handling of the vehicle and throws off the aim of my headlights, which leads to other drivers flashing their high beams at me as my headlamps are shining in their eyes. Hopefully these Sumo Springs solve that problem. I’ve driven about 50 miles post install and can tell the ride is much more firm and stiffened up in the rear of the vehicle. The RAV4 feels much more sporty and planted. The install was much more difficult compared to my Sienna. In our van, the Sumo Springs slid right into place - it was a 10 minute job and I didn’t need to remove the wheels. On the RAV4, this was not the case. I had to remove the rear wheels to gain enough space to work the Sumo Springs into position between the coils. The fit was also much more tight; I had to really jam the Sumos into place and slide them into the center of the coil (it was a real arm workout). The Sumo Springs also overlapped about 2”, so I removed and trimmed each down with a razor knife to achieve a ~.5” overlap (per the supplied instructions). Install time was about 90 minutes as I had to remove the Sumos and trim them - which doubled my labor time. Time will tell to see if these work, but I’ve had a set of Sumos in my Sienna for about 15k miles / 1-year and they have done just fine, so I suspect these will too.

My pathfinder sagged in the rear There was only 40,000 km on it I bout these Couldn’t get them on, took it to muffler man They had to remove and stretch the spring to get it on They installed it for 500 The rear is about 1,5 inches higher

Easy to install on 2020 Mercedes Metris Cargo Van if you remove tire, clean spring and use soapy water to lubricate coil. Reduced "squat" about 3/4" for ~325 Lb. trailer tongue weight without weight distribution hitch.

good ride, easy to install, this is the 3rd set I have installed on my 2018 Tundra TRD Off road, they last 80,000 miles then start coming apart

I would have give it a 5star but the bolts are 1/4” I think it should be at least minimum of 3/8” or1/2” bolts to hold the sumo springs. I like them toed the camper handles very well. Wishi got these a long time ago worth getting. With out camper can tell that it’s there but rides ok. I wanted the same ride it not quite. I ask what the how high they are said 5” with bracket but it’s actually 6” with bracket see picture. I would recommend getting the sumo springs ssr-610-47.

OEM springs not strong enough. After installed feels a lot stiffer and raised the back 2". Material looks really good. Installation done in 40 min using a nut driver, a flat head screw driver and hand soap. I did have to take wheel off it just makes like easier.

2005 Honda Cr-V, they went on pretty easy, it was a tight fit but no trimming required. I jacked the car up on some stands, had both sides installed and zip tied in 45 minutes..

These Sumo Springs were easy to install, even for a 70 year old guy. I tow a 7,000lb camper and even tho I have a nice WDH I still had som sag on my Tundra. These helped level it out when towing and got rid of “some” of the bounce. They were really a godsend when I overloaded the bed with about 2,000lbs of pavers. That weight squished the Sumos significantly but the truck drove and rode great. Better and less expensive than air bags.

Pros: Easy install Drastically helps with sag when towing trailers Cons: Things feel more bouncy in the back when not loaded They get hard as a rock in freezing temperatures (i.e. 15*F = no rear suspension) No option to unscrew the spring and replace with bump stop for the winter (at least that I can find, tell me if they make one).

Fit great on my 2013 Tucson rear springs...don't bottom out now with motorcycle carrier on the hitch...easy to install from the side with the wheels off.

I ordered these for my RAM Promaster 3500 because I had heard from fellow owners that they are a worthwhile addition, for increased stability on the road. The instructions are good, and they weren’t too hard to install myself. They are kind of expensive for a couple of rings of dense foam/plastic, but I guess they must be petty heavy duty. I look forward to my next trip to see how they perform.

Install went fairly easy once I figured out the best spot to put the jack to lift the van. Really helped to have an oil filter wrench to get the old springs off the back. Took it out for a drive after an much better cornering and much less effect from wind and 18-wheelers. This was on a fairly windy day. No big difference in softness of the ride.

Very impressed with the SumoSprings. Was hesitant at first, but purchased a set for my 2017 Hyundai Santa Fe limited ultimate that had a squishy feeling ride and looked like it sat a bit lower in the back. Installed these on the rear springs and raised the ride height 1" in the rear and the ride is much better already. I'll have to see how they do with a loaded down vehicle but without the SumoSprings, 2 adult rear passengers and 2 dogs in the very back, suspension bottomed out over decent bumps and was not a good experience at all!

Fast delivery and easy to put on. Haven't put the trailer on yet, but rides nice with no weight

I waited until I could drive the MH to rate this purchase. They were super easy to install. This difference was subtle but noticeable. Less body roll in corners and in windy conditions. This also resulted in better steering and a more relaxed drive. Well worth it!

Good quality, clear instructions and fast shipping

Initial reaction is positive - I installed front and rear sumo helper springs yesterday (5-23-19) and did a test drive around the block. The side to side pitching of our Transit Class B+ motorhome was greatly reduced. I still need to test on highway. I did not install the optional spacers that increase the ride height and reaction time of the rear sumo springs. The spacers will be added later if needed.

Just finished installing these on my 2014 Ford Expedition EL Limited. Very easy to install. Never removed the wheel to install. Jacked the vehicle up one side at a time and did the install. Haven't hooked to my 30ft camper yet to see how they work. Will update after my trip in July.

Big difference!

Drastic difference from stock bump stops. eliminates almost all extra highway sway/around turns. Beware- - is less than common for the nut that is welded in place that these thread into, breaks free and requires to be cut out via east hacksaw/flush cut. Sumo springs brand send me new, required after, nuts that made install no prob. Apparently this doesn’t happen every time? If I would have know this, I would have ordered the new nuts, just in case. Ask sumosprings about this for more info maybe? But for the price, any van carrying weight/camper needs these!

My NV200 handles better, installation was easy. Just take off the old bump stops and put these on. Perfect!

Love these! Added them to my International Scout and its been a big improvement.

I'm not sure if this picture does it justice, but the before pictire with the boat covered, there is noticeable sag in the rear. Dealt woth that for a year. Installed the coil sumosprings helper yesterday and she's level now. Tip, when installing on an older vehicle with rusted springs, take some extra time to sand the springs until the feel smooth. Do that and the dish soap and they go on pretty easy.

Pretty easy to install. During my first drive with them installed I heard a lot of thumping even over small bumps, but it seemed to work itself out on the second drive. I think it helps level out the slight sag in the rear of the car, and the front wheel drive which used to slip frequently when towing gets better traction. Be aware that for a 2005 Highlander, there are no holes or zip ties, and you can't get the Helpers to stay much higher than the lowest coil. I think them sliding down is what eliminated the thumping.

Ok installed outside january 27th. Temp 10 degree windchill -5. I used canola oil since it stays slippery when cold. I recommend taking off the tires. Also wirebrush the coil spring to get rust and debris off. Coat coil spring in canola oil. Also 1997 crv rear will require about 3/4"-1" off of the helper spring before hand. The driver side took 15-20 mins the passenger less than 5. My car rear was sagging it sits level or slightly above level now in the rear. Mileage of vehicle is 73k shocks struts and springs are original. Curt class 3 hitch is also installed on vehicle. I am curious to see how it does while pulling a 5x8 trailer. Overall seems good only time will tell. Wondering how installing two on a side would do?

Working well to help us deal with a heavy trailer.

Works great even with a rough country 3.5 inch lift made towing my camper smooth

Great customer service. Great website and informational. Stabilized a 1500 with a heavy lift gate. Kept us from buying a 2500 at this time.