# 1
Carr Hitch Mounted Step for 2" Trailer Hitches - Black Powder Coat Aluminum - Black
Excellent product! Installed on my Ranch Hand bumper 2” receiver hitch. Makes it easy to check engine fluids.
Very good quality nice looking product. Just by the looks and feel of it you can tell this will last
# 2
WeatherTech BumpStepXL Hitch-Mounted Bumper Protector and Step for 2" Hitch - 300 lbs
It is all plactic with medal inserts where the holes are that the hitch lock goes through. The bolt they sent was to short. Just a peice of junk for $[XX] bucks. It will not last long.
My wife wanted something that would help her step into our Travato motorhome via the back door. It's built on a RAM Promaster and entering through the back doors requires a pretty good step up to get in. When I saw the BumpStep, it looked like it would make getting in easier, so I figured I'd give it a try. It arrived this morning, took about five minutes to install using the included hardware and it works even better than expected. The only thing you need to install is a 15/16" socket. The step is super sturdy and makes it so much easier to step in and out of the van through the back doors. Would highly recommend.
# 3
WeatherTech BumpStep Hitch-Mounted Bumper Protector and Step for 2" Hitches - 300 lbs
Nice looking bumper step, not too large and no interference with the vehicle backup sensors. Lower step for access to storage and also protection for the bumper from other cars that get too close.
Do not buy a locking pin. I bought one and after almost a year could not fit key in. Had to rent a truck as time was of the essence.
# 4
HitchMate TruckStep Extendable, Hitch Mounted Step for 2" Hitches - 9" x 6" - 500 lbs
Great product for a reasonable price - works as advertized and very strong. Etrailer's customer service was beyond compare - an email was sent to me at every step of the shipping process, and they upgraded me to a superior shipping speed at no extra cost. Great company to deal with and great pricing.
This is a quality piece, for sure, will do the job as intended. I didn't use it in the conventional way, I needed a step on the side of my aluminum-bodied 2017 Ford F250, so I had to make a customized weldment-bracket modification to my truck, and came up with what you see in the photo.
# 5
Reese Towpower Tow & Go Hitch Step for Ball Mounts - 500 lbs
It arrived a day early! Bolted right on in a few minutes, the nuts are set in, so no need for a wrench on them, just the bolt. I run without a tailgate as I put my bicycles in the back so this step is PERFECT. I have a slide in camper, so, no tailgate. I pull a fifth wheel, so, no tailgate. Step on the step, then the bumper and safely into the truck. I already had the hitch, so this bolt on step makes the costs low.
The mounting hardware was loose in shipping box. I know it's made to mount to a reese hitch, but I installed it onto a kurt hitch seems to work well and is a quality product.
# 6
Carr Mega Step Fold-Up Step - 2" Hitch - 14" Long - 500 lbs - Black
It fits our 2017 Transit 150 van, with a Curt hitch from etrailer, perfectly. From the pics you will see it looks like it was designed for this vehicle. It cuts the factory distance to the step bumper in half. My old knees like it. My shins like. . .love the fold up position. Step is big enough that you can hit it stepping around a load in the van. Provides solid footing even when stepping off center. Two issues: 1) The price. A bit steep compared to price of a hitch. But if it helps save my knees it's worth it. 2) The mount is loose in the hitch receiver. Has a tendancy to wobble. Concerned about this surprising others. So I took a 7/8" id flat washer and cut it down to 2" wide with flats on oposite sides. I put it in from the front of the receiver and wedged it under the step mount. This stablized the step. And when it comes time to remove the step I'll be pulling it away from the washer, undoing the wedge.
great company to work with for trailer equipment
# 7
Hitch Stair with 2 Steps for 2" Trailer Hitches
I am 67 with well used knees so climbing up and down from the truck bed was very difficult and not very safe. I received these stairs and popped them on the hitch. I have a Ridgeline so I could open the tailgate from the side and it cleared the step with plenty of room so I could use both steps. I climbed up and climbed down with no real effort and felt more than safe from falling or injuring a knee. It is small enough and light enough to put in the bed storage box so it is was the perfect solution to my problem of getting into and out of the truck bed.
Overall I'm happy with the product. I use it for steps to get in my camper. It's fairly lightweight and small. I can leave it on the vehicle when I'm driving, or take it off if I want a smaller footprint for parking. I have a license plate camera (since my tailgate is off, so my factory camera is removed) and for the most part the camera view is not obstructed by the step. The build quality is pretty bad. I didn't feel like going through the hassle of return the product, but the top step is tilted quite a bit (see picture). It's just sloppy manufacturing. I'll live with it, but it's the reason for the 4 stars instead of 5.
# 8
Carr Mega Step for 2" Hitches - Folding - 500 lbs - Mechanical Matte
Love it, great strong step. Needed little grinding on nuts that hold main plate to tongue assembly, they are too close to hitch entry point, make assembly wider! Pin hole barely lined up due to nuts hitting hitch and after grinding nuts slightly hole was barely lined up. Chamfered leading edge of my locking pin and drove it in with hammer, will have to drive out to tow so pain if its on an off a-lot. Gives it a tight e rattle free fit tho! Don’t expect slip on from package, needs fitting..
It has worked very well. Very pleased with the product. My kids now have an easier time stepping up into the back of my land cruiser. My only "complaint" is that it doesn't fit perfectly tight in the hitch and will rotate very slightly. But, I have never had a problem with it rattling when I drive. Would definitely purchase again.
# 9
Westin HDX Drop Hitch Step for 2" Hitches - 2-1/4" Drop - 34" Wide
It’s a great step not too big and not too small and it looks great.
Love it nobody is tailgating
# 10
Curt Grip Step Trailer Hitch Mounted Step for 2" Trailer Hitches - 6" Drop
The step is great. Welds are very professional. I would say the instructions need to be clearer. It has you putting the end caps on the step first , which should be your last step. You should assemble the plate and hitch 4 bolts and fasteners. Then loosely assemble the side supports (4 bolts and fasteners)so the step slides between the plate and end supports. Tighten the the end supports down. This holds the step in place otherwise its a loose mess waiting to come off. Lastly, attach the endcaps with screws. The video literally states the step is sandwiched between the plate and side supports, but following the 3 step instructions , you will not achieve this result. Please review your instructions.
Great craftmanship...worth the money!!
# 11
Westin HDX Drop Hitch Step for 2" Hitches - 2-1/4" Drop - 34" Wide
What our customers are saying:
"Quick processing, and delivery. reasonably priced very satisfied"