Most Popular Locks Not Included for 2015 Ford F-150

This is a well designed rack. Adding and removing bikes is quick & easy. Just set the bike on & slide the padded hook down onto the bike frame to secure it; no straps required. If only one bike is transported, it does not interfere with opening the trunk on our Tesla Model 3. With 2 bicycles the trunk cannot be opened. For 2 bikes the Swagman model that can tilt might be worth the extra 22 bucks. This rack uses a bolt in the receiver hitch instead of a pin. This locks it securely preventing it from moving in the hitch & rattling. It also requires a wrench to remove it, good for theft prevention but one more thing to keep track of. For storage on the vehicle the top bar folds down. For storage in the garage, the left & right bars fold up & you can hang it using one of the hooks.

So far so good. The rack wiggles a bit, but that is expected. I have it on my 2007 Corolla and I have hit 65+ on the highway with it and have not had a problem. I would recommend getting a locking pin. The one included is threaded, which aside from security, makes it harder to take the rack on and off. I would also look into a DIY way to secure the wheels better. I am using some bungee straps which do the job no problem. The two bikes I carry are at the racks capacity.

I was sent additional mounting materials that don't correspond with my hitch or my bike rack. See the photo below. Are these materials for my Swagman STC2 Bike Rack Item #S64670?

Very stable and simple to use bike rack that works great with my road bike AND with my 29" Big Rippers. It makes loading and unloading the bikes a snap and they are safe and secure for traveling once loaded and secured. I have already logged over a thousand miles hauling bicycles with this rack and highly recommend it. I am a big fan of Yakima roof racks but, honestly, wish I would have went with this setup for my bikes from the beginning.

Doesn't seem to fit the 2024 Chevrolet High Country tailgate as the straps aren't long enough. Also, the padding doesn't go far enough down the outside of the tailgate. Could be because I have the factory bed protection which covers the top of the tailgate.

The product review/installation video helped me make my selection. I selected the full size pad for 2001 Silverado 1500. Installs easily, fits nicely, flap in pad is positioned for easy access to tailgate latch.

I’m a senior and was searching for ways to transport our ebikes without having to lift them. Fortunately I found the Inno Velo Gripper Bike Rack for Truck Beds and installed them on my utility tilt trailer. They work great, were easy to install and no lifting onto a car mounted bike rack needed.

Love this bike gripper system, I have 2 heavy E bikes that I roll up a ramp into my truck bed and quickly secure them with these grippers

Love this product! I built a great bike carrying system for my F-150 using two of these fork clamps. They are easy to install and extremely well made. No more tangled bikes and lots more room in the bed for other stuff! Best way to go for a nice bike rack system. Thanks, Phil T.

Had bought three of these a year ago and placed it on a cut 2" x 4" for three bikes. All three bikes (2 MTB and 1 Road) now easily fit the 5'7" bed of my Ram 1500. No worries with the quick release and no more stress taking the whole family to the trails. So glad I got these.

Have used the block head bike mounts by Yakima on trips of 800 to 1500 miles with no incident. Easy to mount the bikes and they have not released even on bumpy roads. Great product for my truck box and bikes are always in view. Easiest way I have found to transport our bikes

With a little adaption the Yakima brackets mounted to my built in bed rails on my 2010 Nissan Frontier. With my truck cap this makes my bikes safe and secure, out of sight out of mind.

Cheap alternative compared to having to buy a 9mm thru axle mount for the utili-track in my Nissan Frontier AND THEN having to buy an adapter for that! For under $10 I bought some parts from a local hardware store and made this mount fit the track. It's sturdy, and high quality.

My Kuat DirtBag Bike Rack Application Nice product