Most Popular Brake Assembly for 2013 GMC Sierra

Easy brake replacement. Works great..

Exact match to the original. Easy to install. Super fast tracking and delivery. Not one issue. Would definitely buy again.

Excellent. Be sure your axle bearing seals are not leaking grease onto the backing plate.

Brakes work great! I used a self tapping screw to ground the brake to the trailer. This worked really well and I didn't need to run a ground wire. The studs needed a trip to the hardware store to get some 7/16 by 40 pitch (fine thread) nylock nuts. All in all a nice brake setup.

So far so good. Instulation was easy and straight forward. Haven't had a chance to try them yet.

Great availability and product. Fast shipping.

Great availability and really fast shipping. Bolted right on!

Needed all 4 brakes for my 30 foot Airstream. One arrived looking still new, but with minor scratches on the inside face of the brake and the lube worn off compared to the others. The plastic clip that holds the brake wire on the back was also broken off. It could have happened in shipping, as that one box was a bit beat up, and the 5 fasteners that hold it to the frame were in a bag, but floating freely in the box. etrailer offered to replace the whole brake assembly, which I appreciated, but did not feel necessary. They sent the replacement clip and it snapped in as expected adn all is good. I will buy again when time to replace!

Excellent factory part. Direct replacement. Swap couldn't of been easier then removing the four nuts holding the backing plate in place and put the new one on using the old nuts. Resolder the wires and your all set.

A year later still working as should would highly recommend

Easy to install. Quick delivery. I have not tried it out yet but certain all will be good. Will check out etrailer in the future for related products.

The order came on time. The problem was the brake adjustment screw was knocked out of alignment on one of the brakes due to shipping. Able to fix issue. I would recommend etrailer shipping ensure packaging is proper. Both brakes were just placed in a box with a piece of brown paper wrapped around one of the them. So of course they were not secure and bouncing around inside the box. Unsat.

Direct factory part replacement. Complete backing plate swap is the easiest. Spray nuts with penetrating oil. Remove four old nuts on the back and install the new plate and re-use the nuts and your all set. Solder the circuits back together and your done.

Good solid brake shoes, fit on perfectly, in fact the first problem free repair job I have tackled in months. The camper is as unusual as the photo is of Alabama weather.

Just to let everyone know this brake was to replace one on a 2023 Solitude. It was built exactly as the one that came from the factory, except for the ABS sensor that was added in the top of the metal frame. I laid the old and new assemblies side by side and laid out exactly where holes would go, drilled the sensor hole first then drilled and tapped the hole next to sensor hole that matched my original screw which on mine was a 1/4-20 bolt. Once i installed new assembly i just installed sensor same as it was originally, added a little bit od thread locker original bolt had some on it. Spliced the brake wires and Boom it was installed. After rebuilding my drum all i had to do was slightly adjust the brake spindle to my drum and its ready to go. Havent took it out yet to break in pads correctly will be doing that soon. Added a few pics of the old assembly and sensor holes and the sensor once installed. Remember not all RV’s have these sensors.

Package arrived the 4 brake assembles in a flat box,nothing but a peace of cardboard between them. They slid around, banging into each other. Two assembles were partially disassembled and the third had chips broken off one brake lining. I was able to reassemble the two assembles and live with the third. Why not stack the assembles like pancakes in a square box? Not impressed.

Got here fast and I’m great condition. Precise description and exactly what was needed to complete the suspension/ brake repairs. Can always count on Etrailer to get it here fast and right the first time!

One is what I had and the second is etrailer. All I ordered arrived in good shape. Everything fit perfectly. I will definitely use etrailer again soon!! Thanks