Most Popular Command Electronics for 2011 Jayco Jay Flight Travel Trailer

Have not installed yet but looks as described.

OEM product for a great price

The products seem well built. I replaced originals on 5th wheel RV to match new clearance lights. Larger and brighter than the original lights. I would rate it a 5 star if the product included screws and gaskets to prevent water intrusion.

Was the same size as original equipment.

I ordered this product as an exact replacement for the one I had to replace. Placing he order and checkout was extremely easy. Via there website I was able to track the entire process from ordering, handling and the shipping process. Etrailer is company I have in the past and will continue using.

Our tail light quit working during our vacation - we checked with a local RV shop and they told us the part was on back order and they wouldn’t have it for 4 weeks. We found it on trailer and ordered it and had the light in 4 days delivered to the campground we were staying at- Thank you etrailer!!!

Exactly what I was looking for.

Perfect fit for replacement. Quick shipping.

Just got my lights they look great but l will have to wait till it warms up from -15 to install them

Tail light delivered on time and easy to install . LED’s much brighter and visible than the original incandescent bulb. Nice lights!

Quite easy to install and fit my Coachman Freelander perfectly. The prior ones were not sealed, filled with water, and blew the fuse fuse. Beware of the cheaper version on Amazon as they have the same poor seal problem as the original lights which died after <5 years.

Command Triple LED Tail Light Review They work great once they are installed. I have 2002 Gulf Stream Ultra on a Ford E450 Frame. The problem is the actual installation. Command does not include install instructions. What may needed if converting from incandescent bulb to a LED system is a 12 Volt 50 Watt 6 Ohm resistor. Installing a resistor parallel between the Brake/signal and Common wire will be necessary to overcome the hyper-flasher bulb out detection system. This high power resistor needs to be mounted on a metal surface to help disapate the heat created. In my case, I mounted the resistor to 3/4 metal pipe banding. The resistor was suspended so that is would have great air flow. Furthermore, size of the light should be slightly larger than 14 w x 6 7/8 . In my case the tail light was not big enough to cover the old light screw holes. I made this work by centering the light and using lap sealant as a finishing water proof bead. After a long road trip and many signal turns and brake presses the tail lights do look and work great.

This trailer light was an exact match for my original equipment light and easy installation.

I needed a tail/stop light for the rear of my Fairmont railway motorcar and thought from your on-line description that this product would be satisfactory. I was right, it is a good size and bright enough to be very visible in bright sunlight. As you can see from the pictures, to make it match aesthetically I attached the lamp to an aluminum plate cut to fit in an old auxiliary lamp housing. The railway car runs in both directions hence has head and tail lights on both ends. I am very satisfied with this light.