This custom fit kit lets you mount 4 Rhino-Rack 2500 legs to your vehicle with fixed mounting points. Legs mount to vehicle with attachment studs. Includes 4 pads and 4 attachment studs.
Features:
Specs:
Ratings & Reviews
It took me a little while to install because the size numbers for my vehicle were off. But that being said, fast deliver and all the CORRECT parts for my particular vehicle made it a reasonably easy installation. I would order from e-trailer again.
Instructions were a little hard to understand for the first few steps. If there was online instructions, they were not easy to find. Very clean install!
I ordered the Rhino Rack for my 2017 Mazda 3 hatchback. The first thing I was concerned about was if the rack would interfere with opening my moon roof but that's not an issue. However, the rack does whistle pretty loud with the moon roof open at high speeds but that would happen with any roof rack.
For my car, the fixed mounting points on the roof are not accessible with the normal molding strips on the roof. So I had to order new Mazda molding strips with openings that provide access to the roof mounting points. You'll have to research which ones to get for your car. But, luckily, they're not expensive and are easy to install.
Ok, now for the Rhino Rack. I'm fairly handy and have installed roof racks before and the whole install took me about 2 hours. But it wasn't totally straightforward. The directions included in the box were for clamping a rack to the door openings and not for screwing the rack mounts into the fixed points on the roof. So they were not very helpful for my car. In addition, the towers were set up for the clamping arms, so I had to knock that hardware out of the tower arms and install the hardware for screwing down on the roof mounting points.
Also missing from the instructions were the spacing measurements for the roof rack. So I had to go to Rhino Rack's web site and search for the spec sheet for my car to find the measurements. The good news is that those measurements were dead on when I went to screw the rack onto the roof.
What really saved me was watching the etrailer install video for the Mazda 3 (that video was for an older Mazda 3 but the instructions worked fine for my 2017). That will show you how to do it. Once installed, the rack was sturdy and looked great.
I've since installed two Rocky Mounts bike carriers and they are awesome. Although, the forward tilt of the front cross bar (fault of the car's design not the rack) made the install a little tricky and I had to tighten down the bike rack clamp unevenly back-to-front to get it to work. Just thought I would mention for anyone planning on carrying bikes.
The Rhino roof rack looks great on my 2015 Mazda3 hatchback.
Crossbars carry up to 4 SUP boards on a little Subaru wagon. Strong, quiet, trouble free.
Install onto factory fix points was relatively easy, being very careful to not cross thread anything. The numbered instructions had good pictures and were easy to follow. Cut the bar bottom inserts to the right size and the assembled racks fit the car well. Seems sturdy. Attached swagman fork down racks and put bikes on and drove around some to test it out. Time will tell but this seems like a good rack for the money.
It works, yet for the price I expected more precision manufacturing than what I got. Several screw threads had rough spots and there is no way to tighten the nut on the underside of the metal bracket on one leg. It would have been nice for the instructions to mention the wrench for that nut is a 10 mm. And whatever made the designers think the regular user would have the type of torque wrench they require?
Love it, fast shipping, works great and it looks awesome on my car :)
Hey there,
So the product was great, and installation was relatively easy. I have a concern with the pads I received in my box/ the placement of them. And I’m not sure who to contact?
I did not see on the DK sheet specific for my vehicle how to place the pads and which way the arrow should go. So I put them all on with the arrow facing out. The back pads look great but they front pads look odd, and not just the placement but also the pad itself. I’ll attach two pictures to show you the difference in them!
Thanks to etrailer, I am ready to do some serious summer exploring with my 2013 Mazda 3! Rhino Racks, Malone top box, and Kuat bike rack!
Pretty nice rack system. Held up to my 90lb canoe no problem. However a piece did fly off on the highway and the "locking" bar end cap can pull off super easy.
The directions were ok. There is some stuff you have to kind of figure out for yourself, mainly the roof trim. I plan to leave the rack on so I drilled theough the trim
The folks at etrailer are great. Part of my order was backordered and they went out of their way to try and speed up delivery, even with the backorder delivery was very fast.
Installation (2017 Mazda hatchback) was easy but I must have misunderstood the directions because both front and rear spacing was too short (1 1/2"). No problem though as a slight adjustment that only took ten extra minutes at the most to resolve with no effect on the installation. I didn't time it but I bet the whole installation from unboxing to being done took less than an hour and it fits the car, both physically and aesthetically perfect. Pleased customer planning to buy some accessories real soon.
I was able to transfer my Rhino Rack bars and 2500 series platforms from my C-Max to my Mazda 5 with just changing the foot kit from one specific to the C-Max to the fixed point type for the Mazda 5. Some savings from buying a new setup entirely. I took the risk the bars' length might be an issue - turned out okay.
*** In changing the roof rack from one car to another, make sure to buy 4 total of the measuring strips for the roof racks (#RRM641). I didn't think to buy these until I put the rack on and heard whistling at high speed.
Fairly easy installation. Read the instructions thoroughly before hand and get familiar with the parts. Take care when installing mounting studs onto car itself so as not to strip or cross thread them. Once installed they look great.
Rhino Racks definitely has it dialed. My 2011 Mitsubishi Outlander GT with bare roof/fixing points. I'm not the brightest star in the night but the instructions were spot on. It's a rugged yet aero bar set up. The feet anchor securely in the fixing points. Did a quick drive and at 62mph there was a noticeable low rushing noise. No big. When the ski box goes on it's going to break up the airflow.
Rachel was awesome. Very thorough in nailing down what would fit my car.
Thanks Rachel!
Fantastic service. Very happy with this company! Highly recommend it
Great fit, super fast shipping.
Excellent fit for a 2018 Mitsubishi Outlander Sport LE.
Easy install, clear instructions, grandma friendly! Did it myself in an hour.
I've been using this product for about a year now. Several road trips with the family. The product installed and has worked just as advertised. Needed two people for the installation, but that was expected. Overall I'm very happy.
Excellent! Needed some assistance, not much, upon installation but customer service was very helpful & didn't take long to fix what I needed. Great price & have had zero problems with the rack.
Rhino Rack installed on our 2016 Mitsubishi Outlander. Installation took approximately 25 minutes.
Do you have a question about this Accessories and Part?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.