Parts Needed to Install Self-Contained Hydraulic Jack on Lamar Dump Trailer
Updated 11/05/2024 | Published 10/05/2024
Products Featured in This Question
Question:
I have a Lamar telescopic dump trailer I use for work and I'm looking at installing a hydraulic jack on the tongue in place of the regular jack. What other parts will I need to use this?
asked by: Robert
Expert Reply:
Hi Robert; aside from mounting hardware (if you are bolting it on and not welding) you will need to add a 12V deep cycle RV/Marine battery like # 34276285 and some wire to run from the # e33VV to the battery. If you already have a battery the cables are all that is necessary to run power to the jack.
If you're using the battery to power other things like the lift you may want to add an additional battery or a way to charge it so you don't run out of power on the job site. I went ahead and added a chart below for battery cable gauges for your reference. For hydraulic oil RAM recommends using Dexron rated ATF.
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Self-Contained Hydraulic Jack - Square Tube - Bolt On - 12,000 lbs
- Trailer Jack
- Car Hauler
- Dump Trailer
- Enclosed Trailer
- Side-Mount Jacks
- Standard Grade
- 10001 lbs or More
- Hydraulic Jack
- 24-1/4 Inch Lift
- Bolt-On
- With Rectangle Foot
- etrailer
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Dexter Self-Contained Hydraulic Jack- Square Tube - Bolt On - 12,000 lbs
- Search Results: hydraulic jacks trailer jack
- Shop: RV Interior Lighting
- Shop: Square A-Frame Jack w/ Footplate - Drop Leg - Sidewind - 28-3/4" Lift - 3,000 lbs
- Shop: RV Exterior Lighting
- Search Results: dexter axle lift kit
- Search Results: gooseneck extension
- Search Results: 37210715
- Search Results: dexter torsion axle lift kit
- Shop: Torflex Lift Kit - Tandem Axle - 3-1/8" Lift
- Shop: Bulldog Powered-Drive Kit for Single-Speed Jacks w/ 12,000-lb Capacity
- Search Results: electric jack trailer jack
- Shop: B&W Extend-A-Goose Gooseneck Coupler - 2-5/16" Ball - 10" Offset - 24,000 lbs
- Search Results: tjd~12000sp~r2
- Shop: Rubber Bumper for Enclosed Trailer Ramp Door - 2-1/2" Diameter
- Q&A: How Do I Identify My Axles on My Gooseneck Trailer?
- Video: Review of Demco Gooseneck Coupler - eZ-Latch Coupler with Inner Tube Only - DM73KV
- Video: Installing the Dexter Torflex Lift Kit
- Shop: Suspension Enhancement
- Video: What to Know About the GloLight Thinline LED Trailer Clearance or Side Marker Light
- Shop: Lets Go Aero 72" x 32" GearCage T6 Cargo Carrier - 2" Hitches - Steel - 300 lbs
- Video: Install: Seaflo Diaphragm Pump for Boats and RVs on a 2020 Highland Ridge Open Range Fifth Wheel
- Shop: Trailer Hitch
- Video: Comprehensive Review: Ultra Bright LED Flood Light
- Video: Miro-Flex Thinline LED Trailer Clearance or Side Marker Light: The Breakdown
- Video: A Closer Look at the GloLight Thinline LED Trailer Clearance or Side Marker Light
- Q&A: Will Dexter Self-Contained Hydraulic Jack Fit Dump Trailer
- Q&A: Availability Of Hydraulic Jack For Dump Trailer
- Q&A: Sharkfin Camera and Mount that Can be Used with the Furrion Vision S with 5-inch Monitor
- Q&A: Gooseneck Hitch Fit for 2019 Ram 1500 With 5-1/2 Foot Bed
on Trailer Jack
