Solution for Replacement Hub With LM48548 Inner and M12649 Outer Bearing
Updated 09/06/2023 | Published 09/04/2023 >
Question:
Next project-single axle boat trailer. Unknown origin. Numbers: Seal: 205015 Inner: LM 48548 Outer: M12649 Hub: HADOO LA 394 Kit to service this? Thanks
asked by: Brian F
Expert Reply:
Although we do have the # LM48548 bearing, the M12649 bearing and 20515 seal are not something that we carry. If you only need the bearings and seal it looks like they're still available just not here at etrailer.
If you need to replace the hub then your only option will be to replace the axle since that bearing combination is no longer used. For a replacement axle you will need the capacity and the length of the axle. The length is the hub face to hub face measurement.
I have attached a link to all of our axles below, along with a video that explains how to measure for your reference.

Product Page this Question was Asked From
Replacement Trailer Hub Bearing - LM48548
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- 1.38 Inch I.D.
- Bearing LM48548
- Race LM48510
- 5000 lbs Axle
- TruRyde
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: rubber wheel chocks
- Shop: Angle Trim for Enclosed Trailer - 93-1/2" Long x 1" Tall x 1-1/2" Deep - Aluminum
- Search Results: stl72rb
- Search Results: 2 wire pigtail
- Search Results: light base
- Search Results: gooseneck coupler
- Search Results: hydraulic pump
- Search Results: 2" coupler repair kit
- Shop: Even Rub Rail Trim for Enclosed Trailer - 1-1/2" Tall x 1/8" Deep - Aluminum
- Shop: LED Clearance/Side Marker/Third Brake Light - Bullet Light - Submersible - Red - 3 Bullet Plugs
- Shop: Snap-Loc E Track Tie-Down Anchor - Square Mounting Hole - Bolt On - 1,000 lbs - Black - Qty 1
- Shop: TecNiq T80 LED Trailer Tail Light - 8 Function - Driver Side - Submersible - Rectangle - Red
- Shop: Titan Chain Ratchet Tie-Down Strap with Double J-Hooks - 2" x 15' - 3,333 lbs
- Shop: Repair Kit for etrailer and Ram Channel Tongue Couplers - 2" Ball - 3,500 lbs and 5,000 lbs
- Article: Trailer Lighting Requirements
- Q&A: Do Self Adjusting Trailer Brake Assemblies Need to be Initially Adjusted
- Q&A: How to Tighten Self Adjusting Brake Assemblies by Hand
- Q&A: Trailer Light Replacement Lens for Light Marked SAE-A-P2-DOT-02
- Q&A: Are Load Resistors Required when Adding LED Lights to a Trailer
- Q&A: Recommended Staples For Installation Of Carpet On Bunk Boards
- Q&A: Bearing Recommendation for Trailer with LM48548 and L68149
- Q&A: Replacement Bearings and Seal for Dexter Hub 8-147
- Article: Most Popular Wheel Bearings
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: How to Bleed Your Trailer Surge Brakes
- Article: How to Raise Your Travel Trailer Height
- Article: How to Measure for Trailer Hitch Drop
- Article: Where to Position the Trailer Axle?