What is Beam Width Difference Between Standard and Narrow Pontoon Boats

Question

Question:

What is the max diameter pontoon to qualify as a narrow pontoon?

asked by: Mike A

0

Expert Reply:

A standard pontoon boat has a beam dimensions of right at 9 feet and a narrow typically has a 6 to 8 foot beam.

expert reply by: Jameson C

0

Answer 1

Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have are…

view full answer...

Answer 2

The spacing will depend on the axle diameter and on which particular spring hanger kit you use. If you have a 6000 lb 3 inch diameter axle, and you're using the #APT5 hanger kit which includes 7-3/4 inch equalizers and 2-5/8 inch shackle straps…

view full answer...

Answer 3

The 60/40 rule is a great guideline for setting up axle placement on a trailer. But in reality the goal is to place the axles where the trailer will have 10-15 percent of the total trailer weight as tongue weight. The distance you would need to…

view full answer...

Answer 4

The hanger spacing for a tandem axle trailer suspension setup can be determined, but you need to take into account the axle spacing needed for the overall diameter of your wheel and tire combination and the springs you will be using. Lets say that…

view full answer...

Answer 5

Trailer leaf springs are traditionally mounted under the axle. To mount them on top of the axle, you need to use an over-under kit to allow you to put spring seats on top of your axle. If you already have the spring seats mounted on top and bottom,…

view full answer...

Answer 6

Pressure treated lumber can be used for bunk boards along with bunk carpet like the #CE11349. However, it is possible that some corrosion may occur from the chemicals in the lumber over time. The CE Smith bunk boards like #CE27840 are made from…

view full answer...

Answer 7

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

If you are considering Timbrens like the #TDR1500DQ and the SumoSprings like the #SSR-307-47 for your 2022 Ram 1500 4x4, I recommend the SumoSprings #SSR-307-47. The SumoSprings will offer the same quality as the Timbrens in terms of suspension…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

What is Beam Width Difference Between Standard and Narrow Pontoon Boats

Product Page this Question was Asked From

Continue Researching