What Should Tongue Weight Be of Trailer that Carries Boat

Question

Question:

I have a small but very strong boat trailer. Class III with 2 inch ball and says tow up to 5000 lbs and no more that 700 lbs. tongue weight. Empty trailer tongue weight is 150 lbs. now. If I load a 1000 lbs. Boat and outboard, what should my tongue be ? Trailer weighs about 500 lbs. I can change the tongue weight by where I place the boat on the trailer and lock it down - what ideal tongue weight should I work to get ?

asked by: Randy G

0

Expert Reply:

Ideally your tongue weight needs to be between 10 and 15 percent of your trailer's total weight. That lines up with your trailer being able to tow up to 5,000 lbs and up to 700 lbs tongue weight.

So with boat trailers you can get a larger percentage difference between unloaded and loaded since boats typically carry most of their weight at the rear and the axle location is based on that. So if your trailer weighed 500 lbs and you put a 1,000 lb boat on it you'd ideally want your tongue weight to be between 150 and 250 lbs give or take.

expert reply by: Jameson C

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 4

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

view full answer...

Answer 5

Yep, so long as your 2024 Subaru Crosstrek Wilderness is not a hybrid both the Curt and etrailer hitches will fit: - Curt Trailer Hitch Receiver #C13382 - etrailer Trailer Hitch Receiver #e98912 The only difference besides price is the finish; the…

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

Hey Tim, The ZCI Circuit Protected Vehicle Wiring Harness #119250KIT is compatible with LED lights and has been used as a go to for years for people who have LED trailer lights. The light function is supposed send a tiny bit of voltage from the…

view full answer...

Answer 10

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 11

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 12

The only difference between 7-Way Utility and 7-Way RV is the color of the wires. The pin outs are the exact same so either would work just fine with the other. If you check out the picture I attached you'll see that the functions are all the…

view full answer...

What Should Tongue Weight Be of Trailer that Carries Boat

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching