How To Install Furrion Camera On Keystone Fuzion with Backup with Prep

Published 08/25/2021

Question:

2021 Keystone brochure states the unit is prewired for a rear camera, I have a Fuzion 369. There is a rubber grommet where the camera should be located. Removed the grommet and all I see is 1 yellow wire, and multiple white/orange wires which I assume are running lights. I was expecting a connector to plug nfoot playfoot LOL! I suppose I could tap into the w/y wire for power? any advice will be appreciated Thank you

asked by: Steven V

Expert Reply:

The factory backup camera prep packages usually consist of a pre-installed bracket with connector. Therefore, all you should have to do is remove the cover and mount the new camera to the bracket and plug in the connector. That said, the Furrion Vision S Wireless RV Backup Camera System part # FOS43TASF comes with everything needed for models with or without the prep package. If you don't have the connector but the wires are already run then you'd simply need to splice into the wires for power.

expert reply by: Conner L