Baby Moon Hubcaps For 16 Inch Wheels With 8 Lugs

Question

Question:

I am trying to find baby moon hub caps for 16 in wheel with 8 lugs

asked by: Bill C

0

Expert Reply:

We do have exactly what you are looking for, hubcaps that fit 16 inch trailer wheels that have 8 lugs; what you need is the following:

- Phoenix USA Baby Moon Hubcap # PX1309SS

These fit 16" conventional wheels that have a 6 on 5-1/2" or 8 on 6-1/2" bolt pattern, and I have added a link below to a video review for you to check out as well.

expert reply by: Kyle S

0

Answer 1

Since your trailer uses a combined wiring system where the stop and turn signals run on the same circuit, in order to add a third brake light to your trailer you would need to use a 2-Wire to 3-Wire Converter, like part #118158. This will convert the…

view full answer...

Answer 2

You can determine whether either of our baby moon hubcaps, part #AM90086 or part #AM981306, will fit a wheel by measuring the outer diameter of the inner ring and then the outer diameter of the inner ring with one of the tabs (see attached photo).…

view full answer...

Answer 3

I don't know what axles you have on your trailer but if you look at the axle tag it will tell you this. If you can't comprehend the axle sticker then just send me a photo of this and I will be happy to do that for you. There are a few…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 6

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 7

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 8

Since both a ST145/R12 size tire, like the Kenda Karrier S-Trail #AM10130, and a 5.30-12 size tire, like the Kenda K353 #AM10068, fit a 12 inch wheel, a ST145/R12 size tire can replace a 5.30-12 size tire. Keep in mind that these tires do have…

view full answer...

Answer 9

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 10

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 11

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 12

Karrier and Loadstar are two different brand names used by Kenda. There's no difference in quality or function between the two brand names. For a ST175/80-13 Radial trailer tire in load range D, I'd recommend part #AM10210 if you're…

view full answer...

Baby Moon Hubcaps For 16 Inch Wheels With 8 Lugs

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching