How To Replace a Seal On a Valterra Waste Valve
Updated 10/29/2020 | Published 10/27/2020
Products Featured in This Question
Question:
I will be replacing the seals on my Valterra Viper Sewer hoses with the Valterra seal T-201. What is the procedure? removal, prep, install, adhesives etc Thanks
asked by: George
Expert Reply:
I don't really have an exact write-up on replacing the seals for a Valterra Waste Valve like part # T1001B but I do have some info which may help. If you have a 3" then you can use part # T1002-7VP. This kit comes with both seals, front and back as well as the hardware so this is what I recommend using. The old hardware should be able to be removed with a few wrenches. Then, you can separate the pipes and remove the old seal. If you reverse the order above you can get the new seals installed and tightened down no problem.
Product Page this Question was Asked From
Valterra Waste Valve for RV Gray Water Tank - 1-1/2" Diameter - Hub to Hub
- RV Waste Valves
- Straight Valve
- Single Waste Valve - Manual
- 1-1/2 Inch Valve Body
- Stationary Valve
- Valterra
more information >
Continue Researching
- Q&A: 3 inch Waste Valve Seal Recommendations
- Q&A: Visual Difference Between Old and New Style of Valterra 1-1/2 inch Valve Seal
- Q&A: Should I Put a 7-Way Blade or Round in Place of 6-Way
- Q&A: Comparing Road Armor, E-Z Flex, Equa-Flex, and MORryde Cushioned Equalizers for Tandem Axle Trailer
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Does 7-Way Upgrade Kit part # e99011 Fit 7-Way of 2013 Ford F-150
- Q&A: Replacement Converter for WFCO WF-8955PEC for Lithium Batteries
- Q&A: Replacement Sewer Wye for Bristol V33B2R on Cobra Salem RV
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box