Fuse for Go Power Industrial Pure Sine Wave Inverter

Question

Question:

I have approx. 4 foot run of wire to reach my inverter from the battery bank. What rated fuse do I need to use for the IC3000 50 amp inverter. My old inverter used a 400 amp fuse. I cannot find anything on the web to tell me a fuse size. I tried calling but all the recordings wanted to know was about orders.

asked by: Rick

0

Expert Reply:

The correct fuse size for the IC-3000, which we carry with the Go Power Industrial Pure Sine Wave Inverter Charger - 3,000 Watts # 34275013, is 400 amps like you mentioned your old inverter used.

You can get the fuse with cables with the Installation Kit for Go Power Inverters - 400 Amp Fuse # 342GPDCKIT5.

expert reply by: Kyle S

0

Answer 1

The Go Power Industrial Pure Sine Wave Inverter and Inverter Charger #34275013 will output on both sides when inverting. With the inverter you would only have about 25 amps total output but that is split between both of the legs. From shore or…

view full answer...

Answer 2

There's going to be two ways to wire your Go Power Industrial Pure Sine Wave Inverter #34275013 but the transfer switch you have between the shore power and generator power is going to stay how it currently is. The internal transfer switch is…

view full answer...

Answer 3

From what you have described as your goal, my suggestion is one of two primary options, and I will note here that with either option I suggest you have a battery bank of at least 400 AH when fully charged. This first option is not an automatic…

view full answer...

Answer 4

Hey Dave, we can definitely help but we don't have any kits that work as both trailer wiring and tow bar lighting for your 2024 Ford Bronco so you'll need to install both kits separately. But they will work fine together. For tow bar lighting…

view full answer...

Answer 5

Hey Don, thanks for reaching out! The Furrion Chill Cube #FR99TD does have provisions built in to lower the amount of power required to start the unit up. I don't think Furrion officially calls it a soft start (there's debate about that…

view full answer...

Answer 6

For your 58 inch Lippert Edge RV awning the correct replacement idler arm is the part #LC62ED and the correct replacement drive arm (one with the motor) is the part #LC22ED.

view full answer...

Answer 7

Since the system was already working and all of sudden is causing issues for you I suspect that you may be pulling too much solar power for your battery bank causing an overcharge error or a separate system, like your alternator is also charging your…

view full answer...

Answer 8

Hello Anthony, I get what you are trying to do, but it's not a good idea, here is a couple of reasons why: -By creating this loop you will drain your battery too quickly. The converter charges the battery by taking AC power (shore power) and…

view full answer...

Answer 9

Since they didn't list the converter amperage rating on your panel you'll have to just choose the amperage your battery bank requires and then do a bit of investigative work to ensure that the wire gauge used for the converter is enough to…

view full answer...

Answer 10

Hey David, from previous customers of ours who have the same 2020 Keystone Raptor 424 we have determined that your pin box style is the Lippert 1621 which means for a Gen-Y gooseneck adapter you'd want the #GY38FR that you referenced.

view full answer...

Fuse for Go Power Industrial Pure Sine Wave Inverter

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching