What Size Holes Does the Optronics Snap-In Mini License Plate Light Fit
Question:
Will this fit in a hole close to 1 inch?
asked by: Billy W
0
Expert Reply:
The Optronics Snap-In Mini License Plate Light part # LP11CB is designed to fit inside a 1-1/4" diameter hole, no more and no less. Therefore, if you only have a 1" diameter hole then you would need to enlarge this another 1/4" in order for the light to work.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Optronics Snap-In Mini License Plate Light - Incandescent - Round - Chrome Plated - Clear Lens
- Trailer Lights
- License Plate Lights
- Round
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 1-1/2 Inch Diameter
- White
- Optronics
more information >
Continue Researching
- Shop: Optronics Snap-In Mini License Plate Light - Incandescent - Round - Chrome Plated - Clear Lens
- Q&A: How to Replace the Bulb in the Snap-In License Plate Light
- Shop: Peterson Snap-In License Plate Light - Submersible - Round - Chrome Plated - Clear Lens
- Q&A: 5th Wheel Hitch Options For A 2017 Ram 3500 With A Bradford Flatbed
- Q&A: What's Included With The Replacement Motor for Retrax Powered Tonneau Covers
- Q&A: Picking Out Replacement Lippert Hydraulic Leveling Jack Leg for RV
- Q&A: Can Ultra-Fab Electric A-Frame Jack Pull Power From Tow Vehicle
- Q&A: Replacement Remote Receiver For A Retrax Tonneau Model 4100-017 Made In 2010
- Q&A: How To Change Out the Light Bulb Inside of the Optronics Snap-In Mini License Plate Light LP11CB
- Article: Trailer Lighting Requirements
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Guide to Choosing the Best Truck for 5th-Wheel Towing
- Article: Best Camper Jacks
Jerry
2/20/2024
what size hole for a commercial trailer plug