Location of Connector for Remote Pendant PD92201 on Progressive Dynamics PD9245C RV Converter

Question

Question:

Where is the accessory port for the pendant located on the converter? Thank You, John

asked by: John C

0

Expert Reply:

The port that the # PD92201 remote pendant plugs into is located on the side of the # PD9245C unit as shown in the provided photo.

expert reply by: Mike L

0

click to enlarge

Answer 1

To replace your Parallax 7445 converter you can use the Progressive Dynamics 9200 Inteli-Power Converter #PD9245C. This has the same amperage so you can just reuse the wiring running from the converter to the battery bank. The Parallax 7445 should…

view full answer...

Answer 2

It sounds like the batteries being bad are tripping the circuit breaker of the converter on your trailer. If you used 6 volt batteries you would need to use 2 batteries wired in series to make 12 volts or they wouldn't power your 12V accessories…

view full answer...

Answer 3

When it comes to choosing the correct size converter charger you'll simply need 10% of the total amp hour rating of your battery bank up to the max amperage that the battery can handle, which is typically listed on the battery. In your case your…

view full answer...

Answer 4

I recommend you start by just replacing the fuses. If that fixes the problem, you are all set. If not, I recommend replacing the power converter with a new unit. I can recommend a similar model to replace your existing converter if you can find the…

view full answer...

Answer 5

You will just need a 30 amp fuse for the Progressive Dynamics 9200 Inteli-Power Converter #PD9245C.

view full answer...

Answer 6

The generator provides AC amperage to your trailer which is about 10 times more powerful than DC amperage. The 30 amps that you get from it would essentially be 300 amps in DC power available for use. Converters like the #PD9245C charge your battery…

view full answer...

Answer 7

I do have a simple wiring diagram for the Progressive Dynamics Inteli-Power RV Converter and Smart Battery Charger - 12V - 45 Amps #PD9245C. Basically you just need to run the power wire from the converter directly to the DC distribution panel and…

view full answer...

Answer 8

Yes, you can use the Progressive Dynamics Inteli-Power RV Converter and Smart Battery Charger #PD9245C on a set of two batteries wired in parallel with an output of 12 volts.

view full answer...

Answer 9

For flooded lead acid batteries we do have the converter you need, which is the Progressive Dynamics 9300 Series RV Converter Charger #PD69RR. This converter is for flooded lead acid, AGM, and lithium batteries.

view full answer...

Answer 10

The Progressive Dynamics RV Power Control Center #PD4135K comes with an internal Charge Wizard like part #PD92201. The #PD4135K has an indicator light just like the Charge Wizard does, which displays the charging mode that the converter is in: On:…

view full answer...

Answer 11

In storage mode, the output voltage increases to 14.4v DC for approximately 15 minutes every 21 hours to help prevent sulfation of the battery plates. The converter output should be 13.6. When disconnected from the battery, or when the batteries are…

view full answer...

Answer 12

The Progressive Dynamics Inteli-Power RV Converter and Smart Battery Charger - 12V - 45 Amps #PD9245C is compatible with AGM batteries. The converter is compatible with flooded lead acid, AGM, and gel batteries, and will charge the battery to 100…

view full answer...

Location of Connector for Remote Pendant PD92201 on Progressive Dynamics PD9245C RV Converter

Product Page this Question was Asked From

Continue Researching