Recommended Valve Stem Extenders for 22-1/2 Inch Dually Wheels

Question

Question:

your site shows wheel master air valve extenders for 19.5 tires do you have the same kit available for 22.5 rv tires

asked by: Carl

0

Expert Reply:

Yes, we do have a Wheel Masters 4-Hose Inflation Kit for your 22-1/2" wheels available as part # WM8004. This is a hub mount kit whereas the Wheel Masters 4-Hose Inflation Kit part # WM8208 that you referenced is a wheel cover mount kit. However, Wheel Masters does not offer a wheel cover mount kit for your 22-1/2" wheels so the above is your only option.

expert reply by: Conner L

0

Answer 1

If you check out the video I've attached to this page you will see that our installer suggests using a wrench to tighten the connections to help prevent air leaks at the 3:45 minute mark. You may be able to hand tighten the inner wheel using the…

view full answer...

Answer 2

We do have the 22 mm version of the Replacement 20 mm Lug Nut for Wheel Master Wheel Liner #WMRMT9063. The #WM9062 is what you're looking for. Also yes, the Replacement Wheel Master Lug Nut Cover #WMRMT9061 will fit the 22 mm so you won't…

view full answer...

Answer 3

Although we do not have a direct replacement for the Dicor V19582-EJN, the Replacement Wheel Master Lug Nut Cover for Wheel Liner - Qty 1 #WMRMT9061 will fit a 22 millimeter lug nut. From what I have found, the jam nut you are looking for has been…

view full answer...

Answer 4

Hello Mike, Sounds like you are getting things set up the right way and not going over your payload, I respect that. It looks like the weights are the same whether you have a 6 3/4' or 8' bed. If you happen to have an aftermarket hitch,…

view full answer...

Answer 5

Hello Bart, thanks for reaching out. I can definitely point you in the right direction, but I will need a bit more information on your truck before I can recommend the correct tie downs. Can you please answer the following questions for me? 1. What…

view full answer...

Answer 6

The Camco RV and Marine Disposable Water Filter #CAM40043 will last, on average, three months. As you mentioned, that is only a ballpark because of how differently people use it; if you are camping 100 percent of the time it is realistic to expect…

view full answer...

Answer 7

I spoke with my contact at Timbren and he said they don't have an official torque spec for the hardware on the Timbren Rear Suspension Enhancement System #TTORSEQ you referenced but tightening all the hardware to around 20 foot-pounds will be…

view full answer...

Answer 8

the Replacement Toilet Bowl Seal Kit for Dometic Sealand and VacuFlush RV Toilets #DOM35FR is designed to work with Dometic, SeaLand & VacuFlush RV toilets from 2000 or earlier, and will not work with your Dometic 503 toilet. Instead, take a look…

view full answer...

Answer 9

If instead you went with the part #WM8001 over the #WM8002 you'd also get a set of inflators for the outside wheels as well as the inside wheels.

view full answer...

Answer 10

The Lock N Roll Articulating Coupler #336TS502 will come with two 5/8" grade 5 coarse thread mounting bolts and lock nuts. These bolts have a recommended torque spec of 112 lb-ft.

view full answer...

Recommended Valve Stem Extenders for 22-1/2 Inch Dually Wheels

Product Page this Question was Asked From

Continue Researching