Trailer Hub Grease Seal Recommendation for Replacing National Seal 474276
Updated 07/31/2018 | Published 07/30/2018
Question:
I am looking for a replacement for a national seal #474276. Now my question is your seal replacememt,which you say is a match is 1.500 ID x1.987 OD, and mine says it is 1.983 OD. Is that difference going to be a problem, thanks
asked by: Larry J
1
Helpful Expert Reply:
Your dimension of 1.983 is close enough to the dimension of the # 10-9 which has outer diameter of 1.987 and the cross reference numbers match so this would be a fit and would work well.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
- Trailer Bearings Races Seals Caps
- Seals
- Grease Seals - Double Lip
- 1.500 Inch I.D.
- 1.987 Inch O.D
- TruRyde
more information >
Continue Researching
- Q&A: Advice on Replacing Old Surge Brake Coupler with Non Surge Straight Box Coupler Shaft
- Q&A: Can I Replace the Bolt in My Surge Coupler to Secure it in Place?
- Shop: etrailer 7-Way RV Style Connector with Molded Cable - Trailer End - 6' Long - RV Standard
- Shop: Hopkins 7-Way Molded Trailer Wire Connector - 11' Long
- Shop: Hopkins 7-Way RV Style Connector w/ Molded Cable and LED Test Lights - Trailer End - 8' Long
- Shop: 7-Way Molded Trailer Wire Connector, 6' Long
- Q&A: Cross Referencing 10-9 Replacement Grease Seals for Aliner Trailer
- Q&A: Do You Have Idler Hubs for My 2021 Coyote Tandem Axle Trailer Under Robalo Cayman 226?
- Q&A: Replacement Spindle Grease Seal Set for L44649 Inner Bearing on a BT Spindle
- Q&A: What Is the Difference Between a BTR and BT8 Spindle
- Q&A: Measurement of Hole Spacing on Torflex Lift Kit # K71-725-02