Replacement Ramp Hinge Recommendation for Trailer
Published 10/19/2016
Question:
Need hinges on the bottom back pull down door.the hinges that are on it now have rusted. Need to replace them with ones that have grease certs on them. Can you tell what size I need and how many. Its a 1996 thanks sincerely . If you can find the hinges that I need Ill be more than glad to purchase them from you.
asked by: Tom H
Expert Reply:
For a set of ramp hinges with a grease fitting the part # PLR1902 would work well for you.
Overall the hinge measures 8-3/16 inches long, the end pieces are 1 inch in diameter, and the plate portion measures 4 inches wide by 2-5/8 inches deep.
I attached a review video for this hinge for you to check out as well.
Product Page this Question was Asked From
Ramp Door Hinge - 8-3/16" Long - 1" Pin Diameter - Steel
- Trailer Door Hinges
- Ramp Door Hinge
- Greaseable Pin
- Steel
- 8-3/16 Inch Long
- 4 Inch Wide
- Weld-On
- Polar Hardware
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Installation of Ramp Door Hinge Polar 1902
- Q&A: Where Should Kodiak Disc Brake Calipers Be Mounted On A Trailer Axle?
- Q&A: Option For Hinges For Trailer Ramp Door
- Article: Trailer Wiring Diagrams
- Q&A: Does The Fill-Rite Manual Fluid Transfer Pump Require Lots Of Effort To Pump Fluid?
- Q&A: Looking For Replacement Rear Door Hinge On 2005 Haulmark Cargo Trailer
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Q&A: Availability of 72 inch Long Tandem Axle Trailer Fender in Diamond Plate
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Lighting Requirements
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: Can You Flat Tow a 2025 Chevy Tahoe?
- Article: 4 Reasons Not to Use RV Solar Power (And 4 Reasons You Should)