Replacement Wobble Rollers for a LoadRite Boat Trailer
Updated 06/05/2020 | Published 10/03/2016
Products Featured in This Question
Question:
looking for a replacement for a load rite trailer wobble roller part number 4026.01
asked by: John S
Helpful Expert Reply:
CE Smith wobble roller set # CE29210 is listed as a direct replacement for the OEM rollers on LoadRite trailers as well as several other makes. These rollers fit 3/4 inch and 1-1/8 inch roller shafts. they have a diameter of 5 inches and are 3 inches wide. The width at the center hub is 1-1/2 inches. I have included a link to a video review for you.
Product Page this Question was Asked From
Yates Ribbed Wobble Roller - Heavy-Duty Rubber - 5" Diameter - 1-1/8" Shaft
- Boat Trailer Parts
- Rollers
- Wobble Roller
- 3 Inch Wide
- 5 Inch Diameter
- Rubber
- Fits 1-1/8 Inch Shaft
- Yates Rubber
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: CE Smith Ribbed Wobble Rollers for Boat Trailers - Rubber - 3/4" and 1-1/8" Shafts - Qty 4
- Shop: CE Smith Wobble Roller Washer for 3/4" Shaft - Zinc-Plated Steel - Qty 1
- Shop: CE Smith Wobble Roller Retainer Ring - Zinc-Plated Steel - Qty 1
- Shop: CE Smith Wobble Roller Washer for 1-1/8" Shaft - Zinc-Plated Steel - Qty 1
- Shop: Yates Ribbed Wobble Roller - Heavy-Duty Rubber - 5" Diameter - 1-1/8" Shaft
- Shop: Yates Ribbed Wobble Roller - Heavy-Duty Rubber - 4-3/8" Diameter - 5/8" Shaft
- Shop: Boat Trailer 4-1/4" x 3" Ribbed Rocker Roller by Dutton-Lainson
- Q&A: What to Measure to Find Correct Ribbed Rollers
- Q&A: How To Convert Trailer With Slipper Springs To Double Eye Springs
- Q&A: Replacement Slipper Springs for EZ Loader Trailer with 26-1/4 Inch Springs
- Q&A: Wobble Roller Along With Washer And Retaining Ring
- Q&A: Replacement Hub Assembly For EZ Loader Trailer Hub 300-020883
- Q&A: How To Figure Out the Correct Replacement Hubs for EZ Loader Boat Trailer
- Q&A: Parts Needed to Convert 2016 Shorelander Trailer to Electric Over Hydraulic Disc
Justin S.
6/2/2020
I just got a load rite trailer with wobble rollers part number 4026.01. the Bushing and hub width of the oem roller is 1.25" and has a washer on each side. These Ce29210 are 1.5" and in the review he states only using 1 washer is this correct? Someone has replaced a few rollers with yates 530r that are also 1.5" center width, but they used two washers and they been spinning/grinding on the washers and not just the bushing.