Customers compare T92MR to these similar products
Products Featured in this Video
Hi everybody. Andy here with etrailer.com and today we're gonna take a look at this Timbren trailer suspension enhancement system for under slung axles. Now these hollow rubber springs with a 5,000 pound capacity are designed for trailers with an under slung axle that have a 2 3/8 inch to 3 inch diameter. And of course, as you probably know an under slung axle means that the leaf spring sits… see more >
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Videos
Help Articles
Expert Answers
The Timbren Trailer Suspension Enhancement System for Underslung Axles #T92MR is 5-1/4" tall. Timbren recommends The spring be in constant contact with the frame at all times. So ideally you will want exactly 5-1/4" from your axle tube to…
view full answer...Some trailers do have shock absorbers; it isn't all that common but is gaining popularity, mostly among camping trailers. The main reason it's not too common is most people aren't worried about the ride being that smooth. Usually the…
view full answer...Hey Beatrice, To find the right fit for your trailer's suspension you'll need to take a quick measurement of your current shackle straps. You'll need to measure from the center of one bolt hole to the center of the other bolt hole. The…
view full answer...From the mounting surface on the frame of your trailer down to the axle center on the Timbren Silent Ride part #TSR3500S06 measures 5-1/4 inches. You would need to compare that to your current setup to determine if that would change the ground…
view full answer...The brackets on the SumoSprings Trailer Helper Springs #SS26MV are 1-1/2" wide so they will fit evenly across the humps on your spring pads. I do not recommend cutting down the spring and you will be able to use these even with only having…
view full answer...I do have an option for you but the Lippert Components Bolt-On Shock Kit like part #LC281281 is designed for use on overslung axles (leaf springs over axle) only. Therefore, it should not be used with the underslung (leaf springs under axle) axles…
view full answer...It sounds like you are looking for the correct braking assemblies and hubs/drums from a Dexter D52 Axle. If that is the case then we have just what you need, the Dexter Nev-R-Adjust Electric Trailer Brake Kit part #23-458-459 and the Dexter Trailer…
view full answer...Yes, the MORryde Suspension Upgrade Kit #MR46ZR that you referenced is correct replacement wet bolt, bushing, and shackle kit for the CRE3000 kit that you have.
view full answer...When measuring a trailer leaf spring it has to be done with no weight on the spring. You can do this by jacking up one side of the trailer and measuring the spring on that side. Or by removing a spring. It is likely that the springs on your trailer…
view full answer...You will measure the MORryde Suspension Upgrade Kit for Tandem Axle Trailers #MR76ZR from the center of each hole on the shackle strap.
view full answer...If you are getting inside tire wear on the rear axle of your fifth wheel that would indicate that your trailer is sitting a little nose high and putting additional stress on the rear axle. If you look at your trailer when it's connected to your…
view full answer...The recommended clearance with leaf spring suspension on an unloaded trailer is between 2 - 2-1/2 inches. You should have sufficient clearance with your loaded trailer, as leaf springs only tend to deflect 1-1/2 inch when carrying a load.
view full answer...