Replacement Leaf Spring Hangers For Escort/Calkins Tandem Axle Trailer With Offset
Question:
I have an older escort /calkins tandem axle trailer. I am needing to replace the front and rear axle hangers. Mine have a bit of offset at the top to accommodate the slant on the cross member. wil \l any 3 1/4 tall hanger work for me?
asked by: Pat B
0
Expert Reply:
The Front/Center/Rear Hanger for Double-Eye Springs - 3-1/4" Tall # 28-5 would require a similar offset your escort/calkins tandem axle trailer to accommodate for the offset due to the slant you have. This hanger will work with leaf springs that are 1-3/4" wide.
expert reply by:
Bud M
0
Product Page this Question was Asked From
Front/Center/Rear Hanger for Double-Eye Springs - 3-1/4" Tall - 9/16" Bolt Hole
- Trailer Suspension Parts
- Hangers
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- 9/16 Inch Diameter
- 3-1/4 Inch Tall
- Single Axle
- Tandem Axle
- Triple Axle
- etrailer
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Lift Motor for Fantastic Vent in 2002 Teton 5th-Wheel Trailer
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Brake Controller Wiring for Ford E-450 Motorhome
- Q&A: Wheel and Tire Recommendation For Jet Ski Trailer with Tire Size ST175/80R13
- Q&A: How To Charge 12v Batteries Wired in Parallel
- Q&A: Using NOCO 2 Bank Charger With Parallel Batteries in Truck
- Q&A: Recommended 7000lb Leaf Springs To Replace Dexter 072-027-00
- Q&A: Towing a Trailer with Electric Brakes with a Semi Tractor with Air Brakes
- Article: How to Use a Roof Rack (Like a Boss)
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Pintle-Hitches
- Article: How Harvest Hosts Is Becoming the New Standard of the Camping Industry