Comparing O-Track Cargo Control System And L-Track System  

I did some research and found that the Erickson O-Track Cargo Control System like part #EM59133 is very similar to the L-Track systems you referenced. The Erickson O-Track is 18 inches long and includes 2 Spring-loaded O-ring clips and mounting…

Yes, the Tow-Rax L-Track #TWSP24TA and the Erickson O-Track #EM59133 are the same when it comes to dimensions so you can interchange the accessories.

Normally the bags don't make noise if they are rubbing. What is most likely going on is a suspension component is a bit out of alignment and is causing the creaking. The solution for this is to loosen the suspension components you loosened to the…

Based on my research, your Carry-On 5X8G Trailer uses hubs that have a 1.98 inch diameter pilot hole. With this in mind, the correct Bearing Buddy Kit will be one that fits 1.98 inch hub bores like the part #BB1980A-SS. These will replace the grease…

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

If you have the Ford 3" hitch then you can definitely add it but, yes it would change the weight capacity. The TorkLift Cannon Hitch Extension item #TLE1636 only has a 3,600 lbs towing capacity and a 360 lbs maximum tongue weight. If used with a…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

Gen-Y currently only shows their 5" Offset #GY43XR only fitting the 2017 and newer Ford Super Duty trucks. I have included a drawing with the dimensions for this below you can check and see if it will fit your 2012 Ford F-350. If not another…

Hey David, from previous customers of ours who have the same 2020 Keystone Raptor 424 we have determined that your pin box style is the Lippert 1621 which means for a Gen-Y gooseneck adapter you'd want the #GY58GR that you referenced.